IP Telephony and Phones

HI Ive been asked to look at a customer who has a couple of problems , the main one is that the CME GUI is empty. Its as if the GUI has only been installed- clcik on phones - no phone only add, hunt grp - only add. Im not a CME person so forgive me ...

Is there any different licenses used for CUE when it is used with CUCM ? Currently we are using CUE with CME and now we want to use CUE with CUCM but when i am trying to run following commands , i am getting errors given below-- VM(config-jtapi)> ct...

It's kind of rediculous that all phones in a cluster will do a hard reset when you remove a certificate trust. Anyone else run into this? In my case it was necessary because the cluster domain name changed. Certificates were required that the custome...

We have access to Cisco PUT . Just wanted to know need of it . I can download UC applications softwares from cisco main Download section then what is the need of CISCO PUT ? Can i download fresh .iso file for UC applcations for installation purpose ?...

Caller ID not appearing on externall cell phones accross certain SIP trunk connected gateways.

When CFwdALL is set up on our internal phone to an external number,all incoming calls to this internal phone will be automatically forwarded to the selected external number. The external number will wring, but after answer the call, there is no audio...

We have DX650 Phone registered with CUCM 10.5.2 . User have forgotten his screen lock password. When we click the forgot/Reset password button we are shown up with two option to reset by givining google user id and password OR by CUCM user id or pass...

Hi, Is it possible to have more than two dn  in 7941 phone ? Thank you 

HI every one, I have a 7942 all light on and showing blank screen I checked DHCP server , phone didn't get any IP Please guide me Thankx & Regards Sayed

I want to set a greeting message to a directory number in CUCM10.5 1.All calls should be first greeted with a welcome message and should start ringing on reception number. 2.If no one answered the call , it then goes to a voice message. Can anyone...

Attempting to integrate a Cisco 2951 to a Nortel MG1010 via Q.SIG PRI.  When watching the layer 2 debugs, all I see is the Cisco GW sending SABMEs but never receving anything.  Nortel side supposedly sees the same, only sending, never receiving (anot...