IP Telephony and Phones

Dear all I have faced an issue with Cisco ATA 187; the incoming calls are not working, but the outgoing calls are working.I tried to reset it, but nothing changed.Can you please support me on how I can fix it?

How can I ensure support for 6000 users with the BE7000H? Also, how many "VMW-VSP-STD-3A=" licenses will I need? According to the BE7000H data sheet, it indicates support for up to 5000 users only. However, I came across information from "https://www...

Folks, I have these part numbers L-CUBE and CUBE14-T-STD on the smart account, Are these part numbers for a perpetual license of CUBE? if it reaches to the end contract, the service will still be running?

Hello,I ran into an issue with ATT PRI and hope someone can shed some light.We have a ATT PRI connected to a Avaya PBX and we are going to migrate the legacy system to our centralized CM cluster.  I configred a Cisco 2951 ISR router running MGCP.  I ...

Can someone please explain what do you get with just the UCK9 license ?  UCK9 : AdvUCSuiteK9: uck9, cme-srst, cube Currently I have a 4331 (IOS XE 16.09.04, not on smart license) that I am using for data and want to use it as a CUBE, do not need CME ...

 I am unable to connect the routers to the internet. I have the cisco Ip phones 7945s and the 7841s. I have the firmware needed for the phones on my pacstar 447 routers, I have each type of phone in its own folder in my voip folder on the router. I h...

Dear AllI have Cisco CP 3905 phone in our office. I just want to know that it support 3pcc Firmware or not ?Please confirm. I want to register this phone with another vendor IPPBX .Is it possible or not ?

I have Cisco Unity 11.5 configured via sip to a CUCM v14. I have configured voicemail and everything works as expected except for one thing, when users press voicemail on their phone there is a long pause (10 seconds) before Unity will start playing ...

My Finesse profile doesn't have a phone directory - my co worker and CCX customers do. I was able to add/delete contacts for their group directories, I know now that the changes didn't take effect until they log off/on again.I tried various CCX setti...

Hi guys, I have a trouble with my CME, with FOX card, I've configured custome-cptone on voice-port FXO, but when I disconect call from PSTN, the call is not disconnected in my softphone.PSTN --------------------- CME ------------------------- (plar) ...

After Agent answers an ACD call, attempts a Direct Transfer to an invalid extension.Finesse produces the following error and takes about 10 seconds to return back to the active call.     UCCE 12.5.1.10000-24 ES08     Error: Cannot Perform Operation. ...

Hello, We are having an issue with only certain numbers.  The number is dialed then you hear maybe half a ring then silence.  The calls stays connected but no audio and I see sender packets going out but no receiver packets.  the calls flow is as fol...