Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
HIi'm running CUCM 10.5i would to have call history of a directory number (all calls made) and export themis it possible ?? if ok can you help me to do thatregards
Hello everyone,I have a customer who plans to upgrade CUCM from 8 to 10. The old cluster is pretty chaotic and the dial-plan is very bad. So the upgrade will be like new deployment because I have to change all partitions and CCSs, route patterns etc....
Is there a report or a way to determine how many days an IP phone has been idle?
I'm looking for a method or some type of XML configuration that will enable the Cisco IP Telephones to automatically display multiple images while the telephone is not in use…. Something like the screen saver on a personal computer or Kiosk.I’ve seen...
I am trying to update numbers on the additional lines of the cisco 7914 attached to a 7961 phone. It appears that the tech that setup the phone used some USER IDs that started with Numeric Values. I can't update the additional lines because the pho...
Hi all,We are facing a one way audio problem using Cisco 6961 over a VPN tunnel.Not NAT is used. The ipphones on the remote site can't hear the users from the HQ where the CUCM is deployed.The stange thing is is working fine when we use IP Communicat...
Is there any way for me to add a call button on the right side of the phone. I attached an image with arrows pointed to where I am talking about.I want to add an extension over there on the right.
Hello,I have an issue where external caller are unable to reach one particular extension starting as of two days ago but all other extensions work as intended. Extension 2204 is only able to receive calls from other IP phones on the network but canno...
Hello everyone,i am trying to registrate a collaboration phone dx650 to cme 10.5, but i can´t, i have created the voice regisster pool like this:voice register dn 19 number 162voice register pool 16 pin 1234 id mac B07D.47C1.80F9 type DX650 number...
Hello,I am so confuse about SIP trunk configuration,I have a CUCM server with ip address 158.113.41.84 and the CME in srst mode with ip address: 158.113.41.80SIP provider IP address is 172.20.254.252.I need to configure SIP trunk for my CUCM server...
Hello,I have a gateway VG320 register through CUCM with MGCP protocol. Some of the ports FXS after a few days show "shutdown" state with any intervention. Anybody have had the same problem? Thanks Anna.
Is it possible to delete a CUPS server from a CUCM cluster configuration via CLI? My customer had an 8.5.2 CUCM cluster that included a single CUPS node. CUPS was not used and the VM had been powered off for some time. The CUCM cluster was recently u...
Hi! I have several phones 7940 and 7960 that loaded the SIP firmware after a reboot. There has not been done anything to try to convert the phones.Did this happened to anyone else? Tkx Miguel Amaral
Is there a OID anyone knows of to get the # of active calls on a SIP CUBE gateway? This is for a 3825 router with 12.4.24T4 IOS. I've been through the forums, dial-control-mib, voice-dial-control-mib and the OIDs in those return values for each call...
Guys,I need to convert a file for music on hold, what is the right software to convert this file. what will be the right settings for a good sound quality. CME is usinfg G711
