IP Telephony and Phones

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...

call forwarding.png
Translator by Community Manager
  • 5819 Views
  • 14 replies
  • 0 Helpful votes

Somebody can say me why the Called# column is blank when I'm using the IOS command "show voice call status" ?For exemple :#sh voice call status       CallID     CID  ccVdb      Port        Slot/DSP:Ch  Called #   Codec    MLPP Dial-peers0x29C6     26...

I have a user that keeps getting an MWI on their personal extension.  I think MWI is flagged in another mailbox for that extension.  Is there a report to tell me if that extension is flagged for MWI in another mailbox?

shleets by Level 1
  • 142 Views
  • 1 replies
  • 0 Helpful votes

Hello colleagues,Could you please help me to solve one task. I'm terminating sip trunk from sip provider on Cisco 2811 CME:dial-peer voice 2 voip description IN voice-class sip dtmf-relay force rtp-nte session protocol sipv2 session target sip-server...

dfrolov83 by Level 1
  • 449 Views
  • 7 replies
  • 0 Helpful votes

I have two ATA 186's registered to a Callmanager V7.1.  We are located in the UK.  When I plug a modem into the ATA,  I get dial tone, the device dials, . and the modem handshake begins.  The handshake caries on for some time until the other side han...

If I have a certain number range (say) "98[1-8]..$" and I wanted to send that to the CUCM server at 10.1.1.1 but then I had a call (say) "87[1-9]..$" which I wanted to send to "10.2.1.1" using CUBE using e164-pattern-map, how would I create the confi...