Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Rx and Tx that's seen on IP phone when "??" Is pressed..are they same as frame packet size found on stationD message "Start media tranission"?
Can we use the new feature self provisioning in CUCM 10 to self provision Jabber clients ? if yes, how ?Thanks in advance.Khsps
Hello,Do you know if CME support Jabber for Android and Iphone?The follow link it dont have clear information if works:http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/requirements/guide/cme105spc.html Tks
I cannot make outside calls. I am using H.323 gateway configuration and CUCM 6. I have attached configuration file and debug file. I configured H323 gateway and route pattern in CUCM. Please let me know if this is a configuration issue or telecom iss...
Hello I open the server from box and trying to configure it. I set the ip address and all the other details using F8 key. But when i restart the server it gives me the error PXE-E61 Media test failure, check cablePXE-MOF Exiting intel boot agentPleas...
Hello everyone. I have a Cisco 6921 with SIP firmware, and every time I place a call on hold, the Resume button does not pick up the call again. Has anyone got any ideas?
I have a cisco 3925 router and a 4 port FXS/DID card on the NM-HD-2VE card. I wanna connect a PBX to router over one of the FXS/DID port, i think because FXS/DID port is like the FXO port then we must connect a FXS port from the PBX to this FXS/DID p...
Hello. After issues with interdigit timeout and overlapping dial plan, we have noticed that CUCM digit analysis is searching matches in partitions not configured in line/device CSS. The overlapping pattern was in a partition not configured in the CS...
Hello, I am walking through the guide for the Cube line side setup.However, Im missing some of the commands from my router (Cisco 2921 with UC license installed). For instance, I do not have the option of: voice service voip extension cucmorvoice...
Here is the situation: I have a "BOYD" wireless SSID for all employees to use, I would like to move our mobile jabber clients off the current clinical device SSID and onto the new one. As this would be simple enough normally, but our security enginee...
Hi I am a voice administrator in my companyI want to forward all of my calls to my Other location's number.Other location has only POTS line and to reach my extension user needs to go through Auto attendant menu.Is it possible to enter a digit patter...
Hi,I have problem with a UDP flooding from all sip phone 8945 (they are 90 phone) to the SIP SBC provider.The sip provider is Orange with a trunk SIP « Business Talk IP ».System version of CUCM (BE6000) is 9.1.2.11900-12 This flooding saturate bandwi...
Hi , I need to know the difference between Cisco Unified Attendant Console Advanced Version 10.5.2 and Arc Pro Attendant Console? Both supports 10.0 . Is Arc still a supported solution for Cisco Attendant Console ? Thanks,Harish
Hi, Just wanted to clarify the exact procedure for the hostname change for the CUC. As for CUCM, Im & Presence the command is set network hostname, however for the CUC the below link does not mention the same. http://www.cisco.com/c/en/us/td/docs/voi...
hi mates, i have 2 phones that do not have message waiting indicator MWI light does not display on the office phone when someone leaves a voicemail message. the other phones in the office work regularly. voicemail unity 8 and call manager 9where c...
