IP Telephony and Phones

I maybe over thinking this task, but what's the best way to implement call forwarding on a FXO based pots line?    The gateway is MGCP controllered,  I have Route Lists that contain the individual lines. I was hoping to have a route pattern like *771...

We have an Active CUBE with 3 PRI links connected and a Standby CUBE with HSRP running. The question I have is if the Active CUBE fails, is there any way to have a setup that doesn't force a user to manually swap the PRI links over to the standby CUB...

Hello All, I will be grateful if someone can help. I am trying to get X-Lite (version 4.8.4) working with our CME. The phone successfully registers with the CME and I can make the calls out from the phone. But when I try to make a call to the phone I...

Hi I would like to change the number of number of rings before the IP phones divert to voice mail. Currently the phone is on a hunt group but due to staff holidays we are running with 1 staff member. We are on version 9.1. Any advise is appreciated.T...

Hi Guys,Is there any way to create the call handler in Cisco unity expresss Version 8.0.2. If so can any please share the right procedure and steps to configure it. I have gone through many forums and blog but all are poinitng to autoattended only. R...

Hello, I would need some advice on this subject. For a project to replace a older PBX we would need to use a QSIG trunk between the Cisco environment with the older PBX (Nortel). Where would we use this best? On the Call manager itself or do we use a...

All,I have a series of Cisco 7821 handsets that at random times of the day will show 'Phone Not Registered', 'Resetting' and then 'Registered'.I can't see any obvious network issue between the phone and it's Active subscriber.Any ideas how I can prog...

Hi  We have a remote office that has numerous Cisco phones, currently there are 6 phones which are stuck on provisioning and do not go any further. I have had the phones reset to factory default and have checked the power on line and this is ok. Any ...

Hi everibody!Please someone can tell me how can set the answer mode in the EX90 (Speaker or handset).

HiI have Ip phone, connectivity as follows IP Phone-- CUCM ---CUCM has PRI-QSIG with EPABX -- ROUTER IS registered as MGCP Gateway the Location analog phone and Ip phone have same series numbers e.g. 3001 (analog) 3002(IP Phone) But when i call via I...

Hi Guys,  First post and a first time CUCM user so please be gentle with me! I'm looking to see if there is any way I can get a list of extensions, associated IP addresses and agent names. Ideally by logging into the CM CLI and grabbing the info? Any...