Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hello, I have a problem on my CUCM cluster : the ITL.tlv files on the TFTP server (on all CUCM are missing). When i check the file with the URL : CUCM_IP:6970/ConfigFileCacheList.txt i don't see the ITL.tlv the is just : SEPDefault.cnf 17 1 MTP...
Hi Team, FXO and outbound calls while the line not connected to the FXO port, is there a way to do signal detection so the call will jump to the next fxo port
Hi ALL, I am not able to update/add/delete any configuration via GUI.After I save change, the page will hung and need to refresh.IOS: Version 15.2(4)M1CME: Version 9.1 Need you expertise. Thank you.
Hi, I am currently trying to get the following setup working:ITSP -> SIP -> CUBE -> SIP -> CUCM7 The ITSP is g711a with RFC2833 or In-band for DTMF. I've configured on-router transcoding to convert g711a to g711u for the CUBE to CUCM leg of the traff...
HI Everybody,I need Assistance why Cisco 7975G cannot connect to cisco 2911 router.Before the router I connect first to unmanaged POE switch. I attach configuratipn of the router. Thanks,Angelo
Dear Cisco Support Community,I have problem with one Cisco 7970G VOIP Phone. I was reset it (press #, power on and then the orange line leds blink to down I enter the 123456789*0#). The Phone was in the Updating mode. I switch it of from the power co...
We have a multi-cluster environment with UCCE and CVP.Originally, ELCAC was not configured for inter-cluster traffic. (no LBM configured)We do use Locations in CVP to send IP originated calls from remote sites to a combo gateway in that same site.Int...
Hi Everyone,We have Mitel phones connected to 3750s. All IP phones just reboot randomly for some reason. The IP phones are on a different vlan than the PBX controller. There are no obvious error logs and/or reboots on the router (2900), switches a...
I work with Call Manager and the original design has callers calling into the automated attendant and from there secretaries could process the calls further. They did not want dial by extension from the main AA because they didn't want to have phones...
Regarding CUCM 10.5:CUCM is still a little new to me in some areas and I'm still trying to wrap my head around the dial plan options. I have an Avaya background and I understand dial plans and call routing very well in Avaya, but in CUCM 10.5, I see...
Our company is installing callmanager with a few IP phones (7841, 8831, 8945).I am documenting how to use the phones.Based on the user guides for these phones, I cannot tell what the actual difference is between Speed Dial & Fast Dial & Abbreviated D...
Hello All,Trying to get a better understanding of what I'm seeing on our CUBE. If I make an outbound call, I am seeing a single entry for my call when I run the show sip-ua calls brief command. When I make an inbound call to my DID I end up see abo...
Hi Guys, I tryind configuration voice mail in CUE, but, don´t working. I am doing the follow test: I do external call to xxxx.5507 that is configurated call forward no answer and call forward busy. The DN is idle, and when the call try transfer to P...
Hello, CUCM 9.x.Could you please advice me the CLI sql query to get registered MGCP endpoints IP addresses? Thank you in advance.
Hi,Kindly is it possible to queue the calls in UCCX since CUCM not support that Thanks
