IP Telephony and Phones

Calling ALL CME experts ;-)I installed a new 887 and got one IP phone to work. Unfortunately my old config does not seem to work for CIPC, I have the latest version of it. It registers but I do not get an extension number. Here is the output of show ...

My Voice engineer is asking me. "Is our VPN access channel designed to support the 7942/62 remote VPN clients"? We have 5510 FW with SSL anyconnect license. do i need any special licence for voice phones. Maximum Physical Interfaces    : Unlimited   ...

This is my lab environment:VOIP.MS --> 2811 CUBE--> CUCM 10.5.2Attached is my configuration on both my cube and publisherWhat is going on is if I make a call from my IP Communicator phone it does not call out.  Also if I do a debug ccsip all, I get n...

I see issues where whenever I try to reach extensions configured on my Client's Cisco USC320W (example dialing extension 118 always forwards to extension 111 & Dialing 117 goes also to extension 111). If I set the DTMF type to INBAND on my IP phone (...

I have my LG G2 paired with my DX650. I can hand the call off via Bluetooth from my cell phone to my desk phone, but I do not see a "Move" option to do it the other direction. We are running 10.1 of CUCM. Can someone provide some insight into what I ...

Hi, I am installing the Locale Files of the Cisco 7821  phones registered in the CUCM 8.5.1.10000-26, but in the Software Installation/Upgrade I have the following logs:  po-locale-ca_ES- 10.2.1.1000-1.cop.sgnMajor and minor version numbers obtained ...

I make test calls with the phone plugged into the port, but there is no dial tone.You call the port it rings and answers, but when you connect a fax it is getting a dial tone error.The other 3 ports are not configured but they can make outbound faxes...

I added this in the Call Centre section as well , as I wasn`t sure if that related to  UCCX and UCCE or just UCCE so forgive me  I have a current script which references a document- list of users ID`s. I now need to add, modify this lsit to add new u...

Hello, we have wrongly bought some BE6K licenses, even if we have a "standard" CUCM (i.e., installed on a compatible third-party server). Do they work correctly if we generate and upload them? Can we have issues? TIA and regards.

hii would like to make a customer file as ring on my ip phone 7962i have follewed the steps given on this link: https://www.youtube.com/watch?v=RbXb9I4I94Ubut when select placed in rin liste on ip phone i get as message "ring file unavailable "the tw...

Hello ,  One of my clients upgraded  their exchange to outlook.office365.com . Current configuration fax receive called-subscriber $d$fax interface-type fax-mailmta send server mta send subject Incoming Fax Messagemta send with-subject $s$mta send po...

Hi All,     H323 gateway with 2 E1 trunk.   0/0/0 is Primary PRI for ext 64278..... 0/0/1 is Secondary PRI for ext 62135500-62135599   We have pots dial peer which are matching with answering address corresponding DID. IOS version is 15.4 The pots di...

HI  I am not able to complete cucm 8.6 installation on my esxi server, i am getting attached error while installing. please help on this .  ThanksShijo