Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Dear All, Can any one tell from where i get the information from the following productModelEOS RemarkCisco TelePresence SX20Oct-2013 TANDBERG Codec C40 TANDBERG Codec C20 TANDBERG EX60 TANDBERG Edge 95MXPMay-2013 TANDBERG Edge 75MXPMay-2013 ...
Hi Team,We want to have a landline (one single number) to accept incoming calls for audioconference. Could this landline be routed to several extensions (that are routed to Spanish audioconference system) depending if is busy or not?The idea is that ...
We are currently using a monitoring tool for network devices. I have been asked to research the possibility for Call Manager to make an automated call based off of an email/SMS alert from the monitoring software. Though I have been using Call Manag...
Hello,we are facing ringback issue when inbound external call to the cisco phone is transferred back to another extenal number. Call Flow: Cisco phone----CUCM-----SIP-----CUBE----SIP----ITSP. Investigation done:- if both PRACK & EO are disabled, we h...
I have a couple of questions. Below is a simple summary.If 'Phone A' dials 'Phone B', since their DN's are in the same PT, they actually never use a CSS correct? It appears that phones always look in their own PT first, then start concatenating their...
I can't make any calls out this FXO port. Any ideas? Is it a telco issue? IOS is 124-24.T4.bin .Nov 18 06:12:29: htsp_timer_stop3.Nov 18 06:12:29: [0/1/1] htsp_stop_caller_id_rx. message length 0htsp_setup_req.Nov 18 06:12:29: htsp_process_event: [0...
Dear All,Who can clarify for me, what is the purpose of "Document Management" in UCCX ? Best RegardsBahlul
Is there, or does Cisco have plans for a wireless deskphone. Something like a 7841 but works off the wireless. Our aim is to have small offices, or short term sites to have no cabling requirements apart from power.
Dear all,Who can clarify for me, when cisco softphones use Enhanced and Enhanced plus license.1.Which condition needs Enhanced license?2. Which condition needs Enhanced Plus license? Thanks in advanceBahlul
I am getting ready to implement a voice recording solution. We will be using auto recording / RTP forking. We will have centralized recording servers and wish to transcode the G.711 recording streams to G.729 using MTP on the remote site voice gatewa...
Does anybody knows where is documented param "interceptEvents" of set callinfo command?Book "Tcl IVR 2.0 Programming Guide" for Cisco IOS Release 12.3(14)T Doc Release Date 3/28/2005 mentions itin "Table 2 Feature History: callInfo Parameters" on pag...
Hi everybody,for a test lab environment i'm testing the integration between cisco voice gateway 3925 and third party voice gateway by means of isdn PRI.here the connection schema:PSTN (emulated)-----> port0/0/0-Cisco3925-port0/0/1 <------- Third part...
Hi,I never set this up before or know if this is possible. Can I setup email alerts on Cisco UCM 8.X when a scheduled backup fails?I specified the SMTP host under the OS administration page, but that is it.Please let me know if this is possible and ...
Hi All!I have 3 clusters all running CUCM 9.1. I want some phones in Cluster A and B to register to Cluster C. Cluster B phone registered but Cluster A failed. I have enabled Alternate TFTP on phones A and B and set their TFTP server pointing to PUB ...
Hi, Can the VG204XM be used in combination with other products?I mean not Cisco Callmanager or CME?It does support SIP, so it should be able to be a gateway for any SIP PBX Thanks JH
