I have a requirements for a Call Conference Solution to connect branches around 45 Branches,suggest which conference design suits for this requirements in the scenario of CME/CUCM?
Dears,I am trying to upload a firmware for 3905 phones in CME 9.1 but i couldn't, also GUI is not working for me I don't know where things are going wrong with me.Attached are the configsThanks
Hello,I need to block all outgoing premium rate number calls on a CCM - 8.6.2We already have a Calling Search Space called "blocked_premium_Numbers" which uses a partition called "blocked_Numbers".Where do I have to look to see which Numbers are spec...
Hi all!i register my Cisco Unified IP Color Key Expansion Module in CME v10 .On KEM i see blue sceen .If run command 'show voice register pool type CKEM' I see phone with state REGISTERED.But i dont understand how add numbers to KEM. Need configur...
Hi,I am getting "Non Defined IMS Exception" error while login on Presnce Server. I have configured Publisher Presence server on VMware already and now configuring another presence server in other office for backup purpose. I have copied same VM image...
Hi ALL,I have installed 2 Cisco CME in HQ and branch.HQ is using extension 456, 457, 458, etcBranch is using extension 50, 51, 52, etc.When calling out, I would like to add a digit in front of extension or # behind extension to avoid extension confli...
Hello please, i would like to to connect our Cisco CME 2921 router to be able to call our other building using traditional PBX system (Panasonic), i have FXS card already installed on the CME router, please how do i go about this?please, i need a gui...
Hi, I have registered a Polycom IP Soundstation 5000 SIP phone with a UC560 (CME) system.Internal calls work in both directions.External calls work inbound but not outbound. I ran "debug voip ccapi inout" and found that the dialed number has "ABCD" p...
Im looking for more information on configuring the Idle Display for a 78XX series phone. The Administration Guide states that it is an XML file (Text only) but then points to the 7940/7960 instructions for creating the Idle display on those phones wh...
Hello,I have a customer who has a CUCM 7.1(5b) cluster comprising two servers running on MCS hardware.They want to move to UCM 9.1 and I am trying to follow the Jump Upgrade procedure.I have built a replica of the Publisher and that worked ok (I had ...
Running cucm 9.1(2) with 1 pub and 6 subs. Phones that were resently removed from the network are still showing as registered on both the PUB and the SUB. Phone IP address is not reachable from any of the servers by ping. Restarted the RIS and Tomcat...
Hi Guys,My customer recently bought new type of phones 8861 and 8831 for new office, I'm trying to add those phone into CUCM8.5.1, however I couldn't find them in phone list.I'm trying to search its devicepack and patch it, but didn't find 8861 in th...
IP Phone -> CUCM -> H323 gateway -> outbound dial peer that forwards no digits -> FXO port -> FXS port (DN = 9997) -> dial-peer with no direct inward dial command My expectation is that when I dial 9997 that my call would be sent out the FXO port, t...
