Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi,I have wireless phone 7925G with CME 8.6, the wireless phone is connected through wifi and I can reach it from the CME but the phone is not registering and shows the message "not in service", the Status message of the phone shows tftp timeout.the ...
We notice an alert on VMware ESXI 4.1.0 System Board 0 SEL_FULLNESS---Upper Critical Alert 100 Unknown (Under Other)I would like to know what this mean.Thanks,Below system informationLocalhost VMware ESXI 4.1.0 Cisco UCS 210 M2 1.2.3.(J)System versio...
I have Cisco Communications Manager Express on Cisco 3845 and I am getting the following error000739: *Dec 31 10:39:07: %IVR-3-LOW_CPU_RESOURCE: IVR: System experiencing high cpu utilization (98/100). Call (callID=118544) is rejected.and all our ...
Hi,We have CUCM cluster version 9.1.1.21017-2 and we are using two models of phones : SCCP 6945 & SIP 8961.When one of the users with 6945 model try to call to an external destination and the destination is busy or dont answer and then try to press t...
Hi everyone,I am wondering if it is necessary for a call setup to have the following ports opened:Call Manager Express: TCP 11000-65535,Call Manager 7.x: TCP 32768-61000?Thank you very much.
i have problem on fxo gateway when i make call out side on pstn the ip phone make connect direct and billing server make bill the calli need know how to frequency on ksa frquency ring outfrequency outside the mobile is closefrequency wrong number fr...
Hi All,All my cisco 8941 ip phones are not syncing with NTP server which is my gateway cisco 2811.i checked on cucm cli its working fine but the phone time is not getting updated, but when i restart the phone the time will be updated and againg stuck...
Is there any way to forward an incoming call to an external number without tying up 2 lines for the duration of the call? The lines are all analog and PRI Centrex lines. Their current PBX system does this using hook flash. I’ve looked up FXO hook-fla...
Hi All, In reference to the subject of this email, I would like to open a case for a solution we have given to one of our Customer. We are in a pre-implementation phase and trying to simulate the same as needed by the customer. Call...
HiActually we are working on version 7.0 from callmanager but we are presenting troubles with courts calls inbound and outbound, we try to allocate more resources on gateway but more strange is that also occurs locally cut and wit especiffc model 791...
Can anyone tell me the difference between a 7960 set and a 7961....I don't see any difference....Thanks for the reply!!!!
Hi -Last week I had opened a TAC case in regards to phones randomly unregistering from our call manager system. The TAC engineer had ran a query / report from Real Time Monitoring Tool that showed the specific cases of all phones unregistering within...
Hello,I'm looking for a doc that outlines the best practice for rebooting UC servers. I have heard people say it is recommended to reboot servers every 6 months or every 1 year. This is to clear memory or any hung processes.If anyone has come accro...
I have tried the following with solarwinds and Cisco Kits TFTP servers loaded on my Windows 7 PC. I am attempting to issue the command: archive tar /xtract tftp://192.168.3.10/7940_7960.tar flash:however, I receive a timeout error. I can ping the IP ...
Hey All, Previously we had integration to a Nortel CS2100 working great via a SIP trunk.Recently we had to upgrade the Nortel to SE16 and since then I have been having an issue with the following call flow. 1. Call originates from Cisco IP(SIP) phone...
