IP Telephony and Phones

I am bit confused,The scenarion i have Call manager version 9.1 running in Dubai,we have a two branch site in UK & newyork,between sites not interconnected.communication through VPN,user from Dubai goes to Branch site (UK),if they want to  make a cal...

Dear AllHope some one would be able to help me here.I have a problem with Telecom Italia NOT sending me the last 3 digit of the DID.Example:DID is 0651111XXX and Telco is supposed to send 651111XXX to gateway.Most of the incoming calls to gateway wor...

Hi,I am encoutering an issue in which PA is facing issue in tranfering call to Manager.1.Both PA and Manager phones are 7961.2.Both phones are running with SIP load name 41.9-2-3s.3.Checked in L2 configuration found ok.4. It showing requesting on PA'...

Hi all,I am configuring a SIP voice gateway. After finsihing the config, the outbound calls are working properly. But I met some issue for inbound calls.There is no debug log for show ccsip message and show voice dialpeer command. Only q931 has the d...

Hello, Is there any utility available to export CUCM 4.1 configration in Excel as we do in cucm version 7.x, 8.x and 9.x with bulk export utility.Thanks Saurabh       

     Have a CUBE on 3800 with 15.14M(6) with SIP to SIP dial peers. Some external inbound callers at times can hear no audio streaming from IVR.I run a traffic capture from the LAN side of the CUBE and I can hear the audio. I run a traffic capture on...

Hello Engineers,Actually I opened a TAC for a problem that I got in my customer's environment.I have CUCM release 9 and Cisco phone 6901 - firmware: SCCP6901.9-3-2.loadsWhen I tried to see the calls from CAR I didn't get output from the CAR/CDR.I did...

How to find the installed software in CUCM9.1(iso) is restricted or unrestricted??

Hi All,I have some problem with my two H323 Gateways ( 146.44.254.68 and 146.44.254.69) in Call Manager 8.6(2)SU3. My H323 Gateways is Hung.when I outgoing call to H323 Gateway, the call being Fast busy. the digit not yet send to router. when i gathe...

If I am deploying two CME routers for Redundancy , do I need to buy the phones Licenses for both routers ?

hello, i have a cisco 7940 ip phone, can anyone help me to flash it with a new software, i want to use it as SIP.I tried a lot ,it gives me "TFTP timeout oA"  on the screen

Hi,I get this error message when I try to install a license file which I got from Cisco after I copied the request from the ELM.It is the Not for resale UC package from Cisco which included the license.This is a fresh install of ELM 9.1, CM 9.1, CUC ...

Dear Team 1. We are migrating from CM 6.1.3.1000-16 to CM 9.X. I am using following path: 2. Backup the current CM 6.1.3. 3. Fresh Installed CM 6.1.3.1000-16 on the VM machine4. Restore the old CM 6.1.3 backup on fresh CM 6.1.3.1000-16 in VM.5. Uploa...