Hi,Just want to confirm my theoretical understanding of provisioning a 2811. Can the running config be copied from device A and pasted into device B (another 2811 with exact hardware configuration) in order to provision it as a replacement unit? in...
CUCM - 9.1(1)I can report on the total amount of calls per month per number in CAR using:CAR > System Reports > Traffic > Summary by phone number I'm also trying to report on the total number of minutes a phone is in calls over a monthly period too. ...
We're running CUCM 8.5. I need to reset a route list, to add a new SIP router as a secondary outbound cube.What's the impact on current calls/phones if I reset the route list during the day?The new config has already been tested.Thanks ...
Hi,I planned to integrate Cisco IP telephony for one of our customers China branch.Dial plan site is really complicated. Lots of area codes with different lenghts, change of GSM numbering type depend on city exc.Does anyone have any experience on IPT...
How can I make my wireless headsts work without lifting the handset on my IP Phone?
Hi ,I have Call manager 7.1.5 setup.I have setup a Call Pickup Group " RECEPTION_PICKUP"The Main Reception extension is 21500 which is Line 1 on a 7941 Phone and has the call pickup group configured.I have 3 other phones with there own lines configur...
Hi All,I have the following issue CUCM 9.1Phone A = Secretary Phone Type 9951 Phone B = Manager Phone Type 9951 Phone C = Internal extension any cisco phoneWhen a call from Phone C is unanswered on phone B the call forwards to Phone A. If Phone A doe...
Voice Mail redirecting to a different pilot number or extension. Guys need help.I checked with port monitor.When he presses the messages button, it gets redirected to someother user.Any changes that has to be made?Deva.
Hello,I have configured an 2901 cisco router as a VoIP gateway, and when calls from ISDN to IP network arrives I can see that the SIP messages arrives from a port different from 5060 and differs from one call to another. It's possible to set this por...
Hi,We have a global CUCM9.1 deployment and are having issues with one of our gateways in Hong Kong. This is only affecting International destinations through the gateway but results in the telco tearing down the call.The telco have informed us that i...
Hi, My scenario is like this:IP Phone ---> Call Manager---->h323 gateway--->Avaya -----> Avaya phone. I have created two device pools, DP-1 and DP-2 and assigned separate regions to these Device Pools. The codec between these regions has been config...
I'm having problems while trying to register 2 cisco ip phones to my CUCM 7. I've configured 2 dhcp subnets ( in CUCM) to release ip adress to the phones at ( SiteB) router.Also in SiteB router i configured a helper -address into my Voice vlan.The p...
Is there a way in current release 9.1 (or release 10.0) to sync Exchange out of office message with Cisco Unity connection so that the users don't have to manually record alternate greeting?Thanks in AdvanceRegardsOJ
Hi,We have an issue with calls being dropped after a number of seconds, when they get picked up by our voice mail system.See the figure below for a graph of our voice network. Calls are coming in via ISDN, they are transfered to a Gatekeeper with voi...
Hello,I have a problem with my SPA3102's FXS port.In last April I tested my friend's two PAP2T adapters with four phones. The adapters were connected to same switch with different fix IP addresses and phones were able to ring each other. Then I got o...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
| Subject | Author | Posted |
|---|---|---|
| 05-20-2025 07:57 AM | ||
| 05-16-2025 12:03 AM | ||
| 05-12-2025 12:06 PM | ||
| 05-12-2025 06:55 AM | ||
| 05-11-2025 04:59 AM |
| User | Count |
|---|---|
| 5 | |
| 4 | |
| 2 | |
| 1 | |
| 1 |
