Hi All,I need assistance;I have a 11.5 su3 CUCM and UCCX 12.0. I have configured UCCX all internal trigger is working. cti port registered.I also have an ISDN PRI with 100 number range. the current setup is that the first number range is translated t...
Forum Posts
Resolved! SIP Trunk Between CUCM and Asterisk
Hi All, I have a trunk between cucm 11 and asterisk but when a call is made from asterisk to cucm it disconnects immediately it is picked. Any idea?
Greetings, I'm trying to add expansion module CP-8800-A-KEM on CP-8851. Call Manager version is 11.5.It doesn't give any light at all. Phone Active load is sip88xx.12-6-1-0001-668.In Expansion Module : it showsBEKEM-36-Button Line Expansion ModuleONE...
Hello everyone, I have sets of 8851 phones with bekem modules that were connected to Cisco WS-C2960 switches, where everything worked normally. The same 8851phones+ bekem module were connected to fortiswitchs M426E (POE++) and the phone was no longer...
Hi,I am trying to buy some more Cisco phone for my company and my supplier asked for the following information which I could not find.Whether I am using CUCNM cisco BE6000 or BE7000Any help will be much appreciated. ThanksTazio
Does anyone know why when entering a username and password under a service at the self-care portal does not save the credentials at the phone service?This is a setting is under http://cucmFQDN/ucmuserPhone Settings > Services Service8841
Resolved! Route Pattern assignments
Hello, I have a need to create a new Route Pattern for 1 phone. I can do that but how do I get that 1 phone to use the new Route Pattern? Thanks in advance!
We just purchased 4 Cisco 7841 phones and when booted up they are looking for an "activation code". We do not have a corporate network just small office wanting to hook them up to Ring Central. The phones seem to be looking for something when they bo...
Hello community , I'm debugging a gateway to verify if the international call pass or no , can you help with an output or anything else so I can verify ?
I am replacing a 2811 2 port BRI with integrated NT1 and U interface with a 4331. Initially we were advised to use a NIM-2BRI-NT/TE 2-Port BRI Network Interface Module. We found this device only supports voice. We require Data or Voice and Data. This...
How to get report of all ip phones that are in none status in cucm, and is there a way to know when they went into none status
Resolved! Enter your PIN followed by # Repeat?
When dialing or pressing the Voice mail button we get the prompt "Enter your PIN followed by #". If you press the wrong PIN it automatically prompts you for your ID, "Invalid entry, Enter your ID followed by #"Can we have it repeat to enter your pin ...
Resolved! external Calls to UCCX trigger Failing
I need assistance;I have a 11.5 su3 CUCM and UCCX 12.0. I have configured UCCX all internal trigger is working. cti port registered.I also have an ISDN PRI with 100 number range. the current setup is that the first number range is translated to the C...
Resolved! change from mpcc to enterprise firmware
Good day all, Have a 7811 cisco that originally came loaded with the enterprise firmware. ended up loading the mpcc firmware onto it and now don't find any option to revert back. Admin portal/under voice no tabs available for provisioning. stuck on ...
we have two Cisco UCS C220 M4 server's with SBE 6000M Unified Communications Version 11.5how to connect PRI E1 Trunk line to Server
