Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
HI If I connect computer to a VoIP which connected to a Cisco switch, would I be able to see the computer as s CDP neighbor without running any Cisco UC application on the computer?
Hi I know that the Cisco 4000 ISR can be configured as a CUBE to support SIP REC recording.My question is whether I can also use SIP REC for recording if I install 72-port FXS on this ISR?Whether CUBE will also send the audio of the analog interface ...
Hello All, CUCM System version: 12.5.1.13900-152 - 1 Publisher and 3 subscribersI'm having an issue where NTP is unsynchronized. I can sit and use utils ntp restart on the publisher all day long and it never synchronizes. remote refid st t when pol...
Hello,I need to automate the VLAN ID configuration for Cisco CP 6851 model devices. On the device I set to use DHCP Option 132 to obtain the VLAN ID. On the DHCP Server I configured this same option, sending a string with the value 20 (vlan ID). Thro...
When I get routed to a specific user mailbox from an internal number, the greeting plays followed by a message that says the mailbox is full so I can't leave a message.If I call it from an external number (my cell) I can leave a message.In reality, t...
Hi, If I enable master-key using key config-key password-encryption to encrypt passwords as Type6 for the credentials, will the existing Type 7 and other passwords also get encrypted with the master-key? If yes, suppose I have Type 7 key under the ta...
I am looking for a wireless headset compatible with a CISCO 7941G phone in a small business environment
Hello, currently I have SIP phones 8821 with firmware: 11-0-5SR3-2 and url services works properly , but I upgraded phones to firmware: 11-0-6SR2-4 and all works except url service: in phone appear when I click in: Aplications->CME Services URLs : er...
Hi , Facing an issue with BE-KEM registered on CME with 8851 phone. how to remove the customised background from keypad module. please help RegardsUmesh
Hi guys, I am having a problem deploying a new SIP trunk to a customer. The scenery is the following: PSTN———>GW (CUBE)————>CUCM——-------------->IP PHONE PSTN = Internet link with SIP trunk GW (CUBE) = Cisco 2901 router CUCM = CallManager 8.6 IP Ph...
Hi I have registered three 3rd party sip devices to my cucm 12.51- grandstream 33802-grandstream 26133- Huawei espacethey are all registered. calls between grandstreams 3380 and Huawei is working fine. my issue is with grandstream 2613 which can call...
Good day . I can't transfer 6921 phones from SCCP to SIP firmware . TFTPD64 or pumpkin says that the firmware was successfully installed , but nothing happens with the phone . Please tell me what i'm doing wrong ?
Hello All, Incoming calls to my cisco phone show the caller ID, but when the call is forwarded to my mobile phone number it shows my office phone number instead of the original caller ID. Is there a way to fix this? Please help
hi I have a router 2900 cme 7.0 I would like to know what kind of configuration I have to give to the cme 2900 so that the CISCO SPA122 ATA can register with the cme router.
Hello,A penetration test revieled that ssh on expressways have CBC mode ciphers enabled and they asked to disable this.Pen test result: "We have managed to identify that the SSH server running on the remote host is configured to support Cipher Block ...
