Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
We have some kiosks that have Tandburg phones on them. The phone is set up to call a branch number directly upon pickup of the the reciever.The extension set up that the Tandburg dials is a normal receptionist extension and is configured to go to a H...
We have rolled out Voip and voicemail in Poland. For voicemail we have 'location wise" choosen for our German voicemail servers.The default language for the system is German.The people in Poland like to have the English message when they personalized...
(Ext-5200)User#1-------PABX(FXO)-------(FXS)GW#1--------IP-------------GW#2(FXO)-------------(FXS)PABX-----------User#2(Ext-6555)Above line illestrat my topology of cisco Gateway with analog PABX system for voice communications.I just try to brif a d...
Hi all,How can I normally test QoS (queuing)?I have tried with: 1. IP SLA, which is testing Latency, Jitter, MOS, Packet loss for marked (dscp = ef46) and non-marked (dscp = 0) packets2. ping with marked (dscp = ef46) and non-marked (dscp = 0) packet...
Is it possible to have a certain IP phone take priority over all other phones when utilising bandwdith?Thanks
Good morning, I'm trying to understand what type of licenses are below the nomenclature "CUWL Premium", findable in the CUCM ELM 9.0.I know, because I've it in my LAB, that this nomenclature disappears in the CUCM ELM 9.1... but now I've it to the cu...
Greetings! I'm debugging problem with no-way audio h.323 calls. I can't find necessary debug command to see on which addresses and ports (values) rtp-streams were open. I saw next debugs: debug voip ccapi inout, debug cch323 h245, debu...
Is there another way to reset a 7960 to factory default? I have tried the standard sequence but that put the phone into a loop.
We try to use this Audiocodes ip/analog gateway. This box runs SIP.Have you ever used this equipment?What is the configuration of the associated CUCM SIP trunk?Thanks a lot,Regards,Ch.
Hi,I would like to know how to synchonize/adjust the time settings of the CISCO IP Phone 7945? Is this being adjusted at the CISCO Call Manager our CM version that we're using is 7.1.5.35103-1. Currently we the time shown at our IP Phones is advanced...
Hi AllIs there a way to find the volume of calls made to/from the specific DN number.Thanks
Hi everybody.I am just trying to find what cucm versions ca n run on VM ?thanks and have a great day.
Hi All,Fax from rightfax is not landing on gateway ,when sent a fax on number 5540004d.we are getting error "ref cause (27) destination out of order" on Right Fax.Please find the attached traces from CUCM.Right (inter-cluster trunk non gatekeeper) - ...
I need help please , i have a CUCM v8.6 and it is working so fine . Our ITSP decided to use SIP , so i have to integrated with my ITSP using SIP . I have a router with CUBE license and all is ok , i need help for the below:1- What is the best solutio...
Hi im looking for a way that I can setup our out of hours to go to a techs mobile, whilst each tech has there own mobile and rosters rotate looking at how I can do a calendar month for on call techs any. IdeaSent from Cisco Technical Support iPad App
