IP Telephony and Phones

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Hello, gents.I have a CUCM 6.1 plus gateway with 2 working E1 channel. By the request of a bussines i trying to add one more E1.At the CUCM page i already has a two VWIC2-2MFT-T1E1-E1 cards (subunits). I just go to E1 0/1/0 and adjust settings via we...

Resolved! dial peer question

hello, I have the following two dial peers:dial-peer voice 1 voip description local_7_Digit_Calling destination-pattern ....... session protocol sipv2 session target ipv4:203.184.16.2 voice-class codec 1!dial-peer voice 2 voip description national_ca...

fran19422 by Level 1
  • 663 Views
  • 4 replies
  • 0 Helpful votes

Hi All,I was just tasked with replacing an Nortel BCM infrastructure in 4 remote offices with a UC solution which I'm not too concerned about.  The plan is to have my CUCM cluster at HQ take care of the call processing for the 4 remote sites which ar...

Running CUCM 8.6.2-22900-9, when all users are logged out of a hunt group, what should happen if you have configured the "Forward Hunt no Answer" and "Forward Hunt Busy"?  What I am seeing, is that the caller hears ringing until the RNA timeout happe...

Deat Team,When we change the user profile in Active Directory  for example his fax number or ext, there is no sync in the call manager. So  users when make search in the phon they cant fine the userIs this safe to use "Perform Full Sync Now"  in peak...

Dear All,We are going to setup for a DR site of existing DC and the current setup voice communication completely based on IP Telephony using Cisco CUCM version 7.5Please let me know the following if possible :-I'm having the 3 nos of Voice PRI Link f...

sdasgupta by Level 1
  • 502 Views
  • 1 replies
  • 0 Helpful votes

HiI am having DTMF issues on a gateway connected to service provider over ISDN.  I have copied the dial peers used below.  I can see the DTMF digits hit the gateway though (ref debug below).  I have attached config.  Let me know if I can provide any ...

Hi  All,I would like to know about CUCM logs that can be used to analyse calls for1.PSTN calls for both MGCP and H.323.2.Internal calls3.inter cluster calls4.calls to CTI route pointThank you very much in advance