IP Telephony and Phones

Showing results for 
Search instead for 
Did you mean: 

Forum Posts

CCME with vg204 for fax call

Helo guys i am having ccem 2912 and vg204 that is registered with ccme...i have connetced fax with vg304 gateway and having PRI line on CCME router.now i want to send and recieve fax calls over this setup..Please tell me which dila-peers are needed f...

Amit23 by Enthusiast
  • 1 replies
  • 0 Helpful votes

Resolved! 911 Dial-Peer Issue

I seem to be having an issue with dialing 911.  User is getting dialtone after dialing 911.  Here is my config.dial-peer cor customname PSTNname PBX name VOIP!                 dial-peer cor list TargetPSTNmember PSTN!         dial-peer cor list Targe...

mjerickson by Beginner
  • 11 replies
  • 0 Helpful votes

One-Way Audio issue

Dear all,I have one way audio issue between PSTN - GW3845 - CM 6.1 - IP Phone (7911 and IPC)I can read other posts here and guide provide by cisco (http://www.cisco.com/en/US/tech/tk652/tk698/technologies_tech_note09186a008009484b.shtml)I do this abo...

QoS Marking

Hi all,When trusting DSCP marking where should i put "mls qos trust dscp"? On all edge port, including uplinks? Should i also configure this on the core switch? And lastly how can i check that coming from the LAN to the router the DSCP marking was no...

EMCC login error 23

Hi guys,I have configured my vmware machines running two clusters (single node) after watching this wonderful video:https://supportforums.cisco.com/videos/1970I am running two different version of CCM.Home cluster: 8.5.1Visiting cluster: 8.6.2The mom...

tacl75 by Beginner
  • 16 replies
  • 0 Helpful votes

Call Rejection Error

On one of my PRI's we have a few numbers assigned to dial in.  One of the assigned numbers is giving us the error "Your call cannot be completed as dialed, please check the number and try again - Zero Zero Four T".  All of the other numbers are worki...