IP Telephony and Phones

Hi All,Can FAC(forced authorization codes) be configured on cme 7. I have checked some guides and I have not seen anything thing. Any ideas?Also can UC520 cme 7.0 support centralised multisite configurations? The remote sites will be using voip pass ...

Hey guys,when my voicemail dont have a new message but i want to login to the voicemail i dont want to hear "Hello ......, for send a message please press 2. You dont have new messages"The same for recording a message to a voicemail. When i call some...

Dear All I have CUCM 8.5 , the customer wants to encrypt all internal traffic for all phones ??? how ??? it is recoomeded ??? thanks and regards

How do I configure the default voicemail service on the message button to fail over to a second node if the default node is down?There is a nice document on phone services and redundancy describing everything from EM, IPMA, services URL, internal and...

I have a 3745 with a lot of slip secs and error secs on the controller. I am not versed in voice yet but I can tell call quality is not great. Some users report that callers cannot hear them. 3745#sh controller T1T1 0/1 is up.  Applique type is Chann...

hi,I have a lab setup with Cisco UCM 7.0.2 and i have two phones registered to the CUCM , one SIP and one SCCP phone.I have another 3rd party PBX with phones ringing these two phones. I want to enable SRTP and my main question is as follows:to activa...

This issue is when we set up a new user on the CUE. They press the MSG button put in the Default pin and start the Automatic Enrolment. the user will go through all the steps Personalising their msg. But when you call the extension and go to voicemai...

Hello,One of our customer (a service provider) has a UCS-C210 server and wants to install the services of two different companies, the following way:VM1: CUCM Company AVM2: CCX Company AVM3: CUCM Company BVM4: CCX Company BIs this configuration suppo...

I am having an Issue where if I press the MSG button on the phone it asks me for an user ID instead of the PIN not sure why this is happening now as it did work befor.                  

I need to integrate to an analogue Voicemail system(Long discussion). So when calling from one phone to the other we reach the voicemail pilot, but due to the fact that we integrating with Analogue(VG224) the VM provider can only determine which mail...

Hi all,I am plaaning for extra ip phone for our existe voice envinronmentI doubt between SPA504G and 7911G.In 7911G with one license can I activate three phone's, Thus one unit is three 7911G licenseBut with spa504G how many licence do i have per uni...

Hi All,Scenario:CUCM----SIP---gateway---BRI---PSTNWhenever we enable secure mode, the call never works. If we use non secure profile, it works fineThe difference i noticed is that , for failed calls, we see 200 ok with SDP from gateway, but CUCM resp...