IP Telephony and Phones

Here is my config:ephone-dn  99number 43200call-forward all 18900dial-peer voice 18900 voipdestination-pattern 18900session protocol sipv2session target ipv4:<CUE IP Address>dtmf-relay sip-notifycodec g711ulawno vadFor example, ephone 3100 call ephon...

Greetings to all,I had to have the mother board changed on my UCM 7.1.3 SUB this past weekend. Everything is up and running fine I am happy to report. After the dust had settled we discovered that we had not updated the iLo configuration. Since my re...

Hi all,I just got a new 7921G we don't have any other WIFI Phone. I am not the owner of the IPPHONE network and I don't have any experience with CISCO IPPHONE equipment.How can I check if the phone is connected correctly to the WIFI?Messages displaye...

Hi Every one,Does any one configure Gai Tronics Phone in CME 7.X ? Will Cisco CME Support Gai Tronics? Thanks

Hi,I have a setup-CUCM 8.X Cluster and Unity Connection 8.X with IP phones registered globally. Each office has a seperate dial plan(Partition, CSS..) but can directly dial 4 digit extension of remote offices for on-net calls.Autoattendant for front ...

Hi I have a problem with the 7915, expansion module in mi CME 9.1, this is what another user explained several months ago but was not answered"Hi,I am configuring a 7915 module for a 7962G ip telephone on a CME. I'd configured the ephone and upload i...

I’d like to know if I can run a report from call manager that will show me what Calling Search Space value is for the ‘Forward All’ -  Is this possible without checking each line individually?

I have 2 2901 routers connecting an Alcatel to an Asterisk PBX over IP.With the Asterisk PBX connected directly into the Alcatel, calls are perfect but when the routers are in the loop there is a noticable delay in speechI have attached the below cal...

Question regarding CUBAC. When dialing main number from my cell phone, I can here phone ring but doesn't ring on attendant console pc and no alert on queues... Can you please assist.Thanks,

I recently installed cubac 8.6 by following documentaion. i created CTI port device in cucm and CT devices in cubac server sysnchronized. CT Gateway devices are registered but CTI port status unregistered....where did i miss a step? pls see attached ...

Hello,One of the users has a red light in his phone, and also a text indicating he has some voice message, but he logs to listen to the messages, but there is no new messages or saved ones.The CUCM version is 6.1.2Thank you very much for your answers...

Hello,i have CUCM 8.6 (on vmware). Caller ID name only show on between IP Phone to IP Phone not number but i need bothPlease advise,

Hi,             I have  created a shared mailbox number 1118 for extensions 1501 and 1502 , and setup alternate extension for it as 1501 and 1502. 1501 and 1502 don't have individual mailboxes in unity conenction, but are set as alternate extensions ...