Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I need your help in setting up/configuring the ATA 187 on gateway 3925 router for fax services.Thanks,Ali
I have a cluster with 4 subsbribers. The cluster is divided on 2 UCS plataforms.We have installed now a new C210 M2 at a remote site and installed on it 2 clusters of IPCC.Aditionally, we tried to install 1 Call manager subscriber.All the insllation ...
Hello UC People I have a question .. how long should CUCM 8.6 installation take "time"Thnx in advance
As a general rule, should transcoding be done close to the source or destination?Is there any link/documentation that I can reference?ThanksJames
7931phone is not registration cme router 2811
Hi all, hope you are finewell, here is my problemI got a CME connected with PBX, the pbx sip license is only 10 sip trunks, the CME has about 80 registered phone.There is a VIP cisco number that i need to make it reachable from the nortel pbx any tim...
Hi All,I have CUCM 8.0.3 configured with Extension Mobility. The issue I'm facing with: when user tries to log in, user asked for 'change PIN'. I have set PINs via BAT for all the users and that need to be used. How can I disable it?Thanks!Tibor
Is there a method to configure RP (Route pattern ) to block any calls outside working hours ?I am using CUCM 8.6
I have a question to pose to the netpros...I am soon upgrading from CM 4.1 to UCS C200M2 CUCM 8.6. I am wondering...... instead of pulling the PUB from the cluster to upgrade to 7.X using DMA then preforming a bridge upgrade to 8.X. would it be possi...
Hi,We've got a Unity express module version 8.5.1 running a AA script that was created trough the GUI.the aa script plays a welcome message, and a small meny to redirect calls to hunt groups.When we are out of business hours, the A...
I have a few questions I want to confirm:We have CCM 6.1(4) in our cluster that we will soon be upgraded to CCM 8.0(3a).First I want to install CCM 8.0(3a) into the inactive partition on all CCM servers without switching the version (or rebooting the...
Hi,I am new, I have to design a network with 8 port FXO, so I was wondering if the Cisco 2811 could support two VIC2-4FXO card?
Hello to all , I have a publisher, Subscriber recently added both have 7.1.5.30000-1 version. In the new building I have a Cisco 3925, what is happening is that when making a call from outside can not see who perform, does not display the caller ID
I have a scenario for a customer in Europe where they have 2 E1-PRIs, each PRI is configured to allow the first 10 channels to be only for inbound and remaining 20 channels to be inbound/outbound. If I send a call out on channel that is only allowed...
We are getting this error when trying to sync.2012-06-01 13:22:19,539 ERROR [DSLDAPSyncImpl(72515187-27b0-dc9e-01e8-5835e5f4c0d2)] ldapplugable.DSLDAPSyncImpl (DSLDAPSyncImpl.java:608) - LDAPSync(72515187-27b0-dc9e-01e8-5835e5f4c0d2)[Run] javax.namin...
