IP Telephony and Phones

Hello--i'm trying to figure out an equivilent to a CTI route point for CME.  I've got a client who has their existing PBX interconnected across a MAN to a CME system at a remote site, and in order to route calls to a particular number, i need the fun...

Hi all,I have 3 CUCM server in a cluster running version 5.1.3.8000-4 and i've already bought 3 new MCS server for replacing old servers. It is not possible to upgrade the old server to version 7.1(3b) because i don't have Software Feature license. T...

Hi,  I have CCM & Unity 4.x server. Last Sunday powered down the servers and powered ON after maintanence. Post to that, when I dial the number the I should get the Welcome Message, instead it just keeps ringing. When I dial the DID #, calls are land...

Is there a way, either by gui or cli, to send messages from the cucm server to phones?If so, is it a blast message or individual phones/groups?thanks!Ven                

Hello everyone,I have been having trouble trying to get SIP Trunk authentication to work.Im trying to use this as a way of monitoring which trunks are up and down with the end-state and possibly in the future, to be able to display this graphically (...

HiI am getting following error on Unity Express, during, service-module ISM0/0 session from CMESecondary Boot Loader authenticated - booting....   Please enter '***' to change boot configuration: Detect and Initialze network deviceBackup current plat...

Hi,I have one cisco 2911 with CME 8.6 and i would like to know if is possible to configure the following:I have one E1 connected to router with many DDI's.  So i would like every time i make an external call to PSTN i used a diferent Calling Number (...

I'm looking through our unity connections and I dont see a holiday greeting set.  What is the definitive way to check this?

Anyone knows it the cme and cue are able to receive fax over ip without an aditional product?Im looking a solution (reception only) for cisco cme and cue.There is a solution using tcl (on/off ramp) but it works only for FXO ports. I want implement so...

We're looking to track user activities of things like changing their the CallFwd settings whether on the phone via soft key or via the Web GUI [e.g.: someone changes CallFwd on another user's phone. Naughty user!].  We're running CUCM 8.5.  I've look...

I am having an issue with a new CME 9.0 installation. I am attempting to install on a new 2951 router with IOS version 15.2.2T1.When I attempt to accept the license agreement to activate the CME license on the router, the agreement is not displayed a...

Hi guys,I have a problem with the amount of TFTP info exchange between CM and IP Phones. We are checking and during the day, the Ip Phones sent and receive a lot of information from CM using SCCP. But using SIP the amount of traffic is minor.Did you ...

Hi,I started out helping someone with a CDR problem at https://supportforums.cisco.com/thread/2157119?tstart=30Unfortunately, I mis-read the question, and made a pigs-ear out of answering it. Can someone help the poor sole ? I suspect a call to TAC i...

I have a issue where hunting between POTS dial peers (FXS port) does not work. The Dial Peers has the same destination Pattern configured (4010).The wanted behaviour is for the call to hunt to the next dial peer when there is no answer. I know that i...

Hi guys, if anyone knows how to connect my call manager (publisher) to two core switches 6509 to be able to have redundancy so if one of my switches goes off the secnd switch will be able to keep the cucm up and running. I want to be be able to have ...