IP Telephony and Phones

We use Sprint as a switched long distance provider. Sprint is configured to prompt for a long distance access code when certain numbers dial long distance, and not prompt for others.Until I migrated from MGCP to H323, this worked fine. Post migration...

We upgraded from 5.x to 7.1(5b)SU5 last weekend and then did server rebuilds of 7.1(5b)SU5 due tp partition size limitations this week.  2 days after the server rebuild, it was found that on a 7942, we are getting a "error code 4, parsing error" when...

HiI am new to fxo cards and need some help setting one up.I have a Cisco 2610XM Router with a FXO and a FXS cards connected to a cisco call manger server. I have got it all setup apart from incoming calls.I want it setup so that if someone dials the ...

I have a curios case with the hold and transfer features in cme and 3905 sip phones. There is not sccp phones.The SIP SP give us a sip trunk with two headers, 3185840 and 3185860. I already setup the AA for both numbers. Incoming Calls from SIP TRUNK...

Hi Guys,I'm configuring a SNR (Single Number Reach) for a CUCM 8.6 but i have a lot of ancient IP Phones (7905G, 7912G, 7940G, 7960G) and i am not sure if this feature is supported in these IP Phones because when i tried to make the template for soft...

I hear rumors of CUCM (or somewhere within Cisco UC) that on version 9.X, Call Recording will be supported/doable internally and will not need an external/third-party solution.Has anyone heard anything similar. I currently use ANDTEK's ANDPhone CallR...

Hey all,I need to determine the current cube version running on my 2921.   Any idea?

Hello,We currently utilize the service parameter "Incoming Calling Party National Number Prefix - MGCP" to prefix all inbound calls from the PSTN with "91"We are implementing Mobile Connect on a number of employees.  The issue we have is when a call ...

Morning all,Can anyone tell me if this is still a solution Cisco give? If you browse to https://apps.cisco.com/qtc/config/html/configureHomeGuest.html you cannot chose routers etc. What i am doing is just trying to see what modules will fit into a ce...

Please, i need help.... we have cisco unity express 8.6,i need enable emal notifications... i followed the administration GUI, but it seems not work...In message notifications--->notifications administrations---> enable system wide notifications---->...

Imagine I have future site to design with 2,000 Cisco IP Phones 7962G . There are 200 analog phone lines that need to be maintained as analog phone lines.I will install 1 CUCM subscriber and publisher and subscriber will be housed in a collo facility...