Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Is there a single command that can pull an inventory list of what IP phone load my IP phones are using, so I can determine if I have IP phones with phone loads that are too old to be upgraded to the most currrent phone load version?Additionally, if I...
Hi guys,I have this issue on a CH greeting. A personalized greeting has been recorded on the call handler greeting (closed), however the CH wont play this greeting but will rather play the recorded name. So during closed hours, you hear sorry "call h...
Hi,Can anyone help me with UCM licensing for CP-3905 IP phones. As I know, only CP-6901 & CP-6911 phones require basic license, all the other IP phones use Enhanced license. Being a SIP phone, what license is required for CP-3905.Regards,Sagar
Hi Team,I need to integrate an IP 7000 device with CME version 8.6. I understand that IP 7000 talks only SIP. So, first of all I would like to know if this integration is posible. If it is possible, I would like to know what the required IP 7000 firm...
Hi Team,My customer requirement to configure Polycom® SoundStation® IP 7000 Phone with CME 8.5. I tried searching the compatibility matrix in Ploycom site and as other but no Luck. I found Call manager will support IP 7000 phone registration as SIP e...
Hello, could you help me. How I can assign service(external dir service) button on sip phone Cisco 9951. Thanks in advance
Scenario:During a scheduled DR test, an IP phone is registered to CM1. Next, the DHCP server connectivity is lost just before connectivity to CM1 is lost. The phone goes into temp fail, tries to register to CM2, but loses its IP address and are now...
Implementing RightFax with MGCP Gateway and SIP trunk with CUCM 6.X.fax --->(pstn)--->MGCP gw--->cucm--(sip trunk)----->rightfax server7 digits gets translated to 5 digits via translation patternGot a pre-dotted RoutePattern leaving last 4 digits rou...
Hello,I have a H323 gateway with two PRIs used by different BUs within the same Unified CM cluster. I would like calls from a particular BU pick a particular PRI on the gateway. Is there a good way of accomplishing this?Thanks
Has anyone else encountered an issue with outbound dialing 800 numbers when enabling caller ID with name? When dialing, we receive a fast busy. Below is the dial-peer and serial interface config. As soon as I removed this from the interface: isdn...
Running CM 5.1.2, there is no method to BAT update all 7941 and 7961 sets to set Web Access = Disabled.This option exists for 7911's.Bug, or undocumented feature?Any workaround?
Hi all,Just wondering if this would be possible. Here is the scenario that our GM would like to happen.We would have a 1-800-XXX-XXXX number be redirected to our General number 123-456-789 that Reception would answer during the daytime when the offic...
Hi All, Need your assistance urgently. We are unable to pick the call from another phone when the call comes in the hunt group. Ex Example: Phoen A, B and C are in the hunt group. We call to their DID, after IVR call lands to phone A, now we ...
We are upgrading from Cisco Unity Connection pair from Version 8.5.1.ES65.13900-65 to 8.6.2.21900-5. We want to limit downtown. Curious if service remains up on the secondary server while reloading to the upgraded partition, then vice-versa?
Hi Folks,I have a weird case with extension mobility feature.I'm using CM 8.5.1.10000-26 with several IP Phone series like 6921, 7945 and 9971.I've check the EM configuration on call manager and all configuration should have been configured properly....
