Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Is there a way to prevent MOH from running in a conference call? We have a group that holds training via the conferences and occasionally a user will place them on hold and the MOH disrupts the training session.Thanks in advance for any help.
Hi All,I would like to know if is possible make disable the MOH when you put in conference or during transfer process, this only for a couple of phones only. I already set a silence MOH for a couple of phones, when they put in HOLD this is working bu...
HI,I have CUCM 6.1.5 and the 2821 router as a H323 gateway.My problem is that Call Transfer, Call Hold and Conference not working.Regardless of whether I call or receive calls, when I want to do a call Transfer, or even call Hold, and Conference, th...
i have a customer using CUCME V8 on a 2921.. customer is looking for an attenandt console like applicaton and I am wondering if the cisco smart call connector operator is compatiable with CME
Hi, On UCM 8.6 my option to configure the SIP device security mode is set to Non Secure and is grayed out. I do not have the option to set it to either non secure, authenticated or encrypted like all Cisco documentation says I should be able to. I am...
Hello,I'm new to the site and would appreciate all the assistance I could get from everyone here. Thank you in advance...When I dial the intercom number of one of my phone, it takes at least 10 seconds before it rings (the caller hear dead air during...
We are curently running CallManger ver 7.0.1.11002. The current firmware on the 7941G is SCCP41.8-4-1S and we want to upgrade to firmware version 8.5(2). Looking at the release notes it talks about device packs. What are device packs? Is that som...
Is this possible? Here at HQ we're on a full blown Call Manager which allows you to create a CIPC profile and simply install the IP Communicator applet.It's been requested by an off-site business unit who is situated with a CME ver 7.1, he would like...
I have a 2851 at customer site. It has 2FXO for SRST and 911 calls. I can call 911 going out the FXO port but when I get a call back the second FXO answers after 2 or 3 rings and gives dial tone , and you can make a call out. If I look at the Dial...
We are still back on the unsupported vers 4.3 Call ManagerI need to do a db dump from sql analyzer of all current phones in use. The business would like to distinguish what DID's from which blocks are mainly being used.Basically an overall subscriber...
we met site to site one way audio, how to see one way audio log which are collected by RTMT8.1?and find relatived reason?
Not sure how this all works as cisco licensing is sometimes more difficult than getting the product itself running. I'm doing a unity 5.0 to unity connection 8.x migration. It looks like what was ordered was the unity upgrade (CON-ESWUNITY8V & UNITY8...
I am shortly retiring a gateway that has transcoder resources configured (it is no longer doing any PSTN termination). I did not want to remove it from MRL's until I was sure it was no longer being used. I set an alert in RTMT and have been running t...
Hello Team,BARS is the tool for backup and restore of the database of a CUCM cluster. Is there any difference in the result when changing the HW of a cluster with the following procedures:1) Install new publisher server, restore the whole BARS backup...
I have an ISDN30 with 20 voice channels. I'm looking to restrict the number of outbound calls to 15 so that there are always 5 free for incoming calls.Is there a Global equivalent of the dial-peer max-conn command?Thanks
