IP Telephony and Phones

Dear allIin cucm subscriber intsllation is finish/ after installation .unfortunatily need to change the ip address sub after changing ip using this command show network etho link detected is stage is nonot able communicate other systems even gateway

HI all,I have one pub and one sub after changing the ip address of sub show relication status is belowadmin:utils dbreplication runadmin:utils dbreplication runtimestateDB and Replication Services: ALL RUNNINGCluster Replication State: Replication st...

Hi all,I have MGCP GW, registered with CUCM 8.5, the gatway has 3 fxo they are grouped with one Route Group, this route group is member of route list, when I try to make a call from this route list, the call always go through one fxo port 0/2/2, and ...

Hi,I need to check if the CME license can be converted to CUWL license. My customer has CME license for Cisco 2800 series but the customer is now moving to centralized call processing model with CUWL. Is there a way we can covert the CME licene to CU...

Hi all,I have config the AA but how can I enable the dial by extension ?CheersLeung Che Man

We are trying to change the background image on a IP Phone 7945. We have uploaded the list and png files, and restarting the TFTP service and phone. Here is an attachment of the files.

Dear all,(1)How to config the 2960 POE switch for AVAYA IP 500?For example ,QOS and vlan,trunk between two 2960 POE switch (2)Do I need to disable the POE function when the port is be connected to another switch without POE function Please give the d...

Hi there,I just need to know if below MCS server can have both Communications Manager and Contact center express application active (co-resident) on the single server?MCS7816I4-K9-CMD1                                  Unified CM 8.0 7816-I4 Appliance...

   Office is in south ameriacah323 gaetwayextensions are 4XXXX so when I call in it's 901155114505XXXXSame with outboundI have my 2 voip dialpeers with the target of my 2 CCM's in the clusterMy debug shows the call comming in with the  last 4 digits ...

I'm trying to install Unity Connection 8.0.2 on UCS B200 through OVA template.It creates the VM fine, but when it come to install Unity Connection, there is no option for Unity Connection!Only Call Manager and BM Business Edition is listed!If I put i...

Does Licenses get backedup when you take backup of the call manager.?I am going to replace my harddisk in the MCS 7835 which is currently running call manager 7.0(1) and going to rebuild that using bigger size hardisk. So i am planning to take backup...

HiCan we have auto-attendant feature available on CME running on 3825cheers anthony

Hi Alli have a site connected to the PSTN through FXO CARD , when i configure the plar on the router as normal ip phone the line become onhook and after i disconnect the call , the port become offhook without any problem , BUT when i configure the pl...