Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi,there are 3 sites with 30 users each... in each site there is an internet connection 1 mega.i want to connect the 3 sites via vpn to have free calls, and they have very small data to be exchange between them...what is the low cost to user in each ...
I am planing to upgrade my CUCM to 8.6 from 8.02, I want to know what file do I Have to download there are two versiobs onr that is restricted and one unrestricted , what is the difference betwen those . Are there diferences with the licensing of the...
Hi,I have already installed a CTL Client and phones do not register with de CUCM while applying Security (security mode cipher).Following steps are done:- CUCM in Mixed Mode (Cluster Security Mode 1)- Cisco CTL Client installed with two Tokens- Reset...
hi all,please let me know the steps to find ip address of the ip phone ThanksKarthik
Hi,Where can I download wip310 new 5.0.13 firmware? is not ready right now for downloading.any idea?regards
Hi,I have a Call Manager 7.0(2) Cluster in a HQ with 9 remote sites. Each site has a hardware conference bridge configured on the gateway. All the MRG's and MRGL's are set up identical for each respective device pool and all the IOS configs are ide...
Hi,we purchased two UCS C210M2 and we want to install CUCM, unity connection and presence. The two UCS will be located in two different locations for redundancy so we will have cluster over the WAN for CUCM. Can we have the same for unity connection ...
What would cause a 7960g to shut off when the ethernet cable is connected? No PoE is being used, power comes from power brick.Andy
Hello to all,I have a Cisco 2811 router, running IOS version 15.1(4)M and Call Manager Express 8.6. I have also setup the router to serve out SIP to a few Cisco 9971 SIP phones. I have been able to work out exactly the config required for these phone...
We need to accomplish encrypted RTP (SRTP) between cisco phones running sip and skinny images. We also need to encrypt the singaling traffic between sip/skinny cisco phones and mgcp and h323 gateways.To allow for encryption (not authentication) do w...
Hello all,I have a situation here, with a CUCM 6.0.1, with the following simptoms: 1) Conference with all stations configured (under the same region) to use G711: conferencing is OK;2) Conference with all stations configured (under the same region) t...
We really need to find out if an ext if associated with another mailbox(es) Example. If a user leaves and the ext gets reassigned the ext is still listed as an alt ext with MWI. The user inheriting the ext will still get MWI and have access to the ma...
I was following the steps from:http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a0080b43504.shtmlOn the 6th step of "Upload the Certificate to Cisco Unified Communications Manager" section, the "upload file" ste...
Good Day Networkers !!!. I know that the CUCM cluster has one publisher and maximum of 8 subscribers with only 4 active call processing servers. Please find the attached sample CUCM cluster representation. I am not clear on how physically the publi...
I need to create some trace logs for a call loop that is happening between two clusters via non-gatekeeper controlled Intercluster trunk. Can anyone recommend a best trace is best for this? This is on CUCM 8.0.
