Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi there,I am having some issues with mi Ex90, for making transfer.My endpoint works perfectly making direct calls to other sip or sccp devices.The problem is when I transfer a call to my ex90 I can listen to the other side but they can't listen to m...
Hello,anyone experienced similar problem with the "If Step", in UCCX Editor 7.01:when attempting to edit its properties to put a condition it say "Nothing to customize"Thanks.
hi all,please explan me the difference between cucm 7.0 and cucm 8.5 thanks in advanceKarthik
Hi All,The scenario is as follows we have both E1 cards and Analog lines connected to FXO car\ds. We want to cut off certain lines after X amount of minutes if they are talking over the PSTN. I was thinking if we can implement some sort of tcl scr...
Hi,there are 3 sites with 30 users each... in each site there is an internet connection 1 mega.i want to connect the 3 sites via vpn to have free calls, and they have very small data to be exchange between them...what is the low cost to user in each ...
I am planing to upgrade my CUCM to 8.6 from 8.02, I want to know what file do I Have to download there are two versiobs onr that is restricted and one unrestricted , what is the difference betwen those . Are there diferences with the licensing of the...
Hi,I have already installed a CTL Client and phones do not register with de CUCM while applying Security (security mode cipher).Following steps are done:- CUCM in Mixed Mode (Cluster Security Mode 1)- Cisco CTL Client installed with two Tokens- Reset...
hi all,please let me know the steps to find ip address of the ip phone ThanksKarthik
Hi,Where can I download wip310 new 5.0.13 firmware? is not ready right now for downloading.any idea?regards
Hi,I have a Call Manager 7.0(2) Cluster in a HQ with 9 remote sites. Each site has a hardware conference bridge configured on the gateway. All the MRG's and MRGL's are set up identical for each respective device pool and all the IOS configs are ide...
Hi,we purchased two UCS C210M2 and we want to install CUCM, unity connection and presence. The two UCS will be located in two different locations for redundancy so we will have cluster over the WAN for CUCM. Can we have the same for unity connection ...
What would cause a 7960g to shut off when the ethernet cable is connected? No PoE is being used, power comes from power brick.Andy
Hello to all,I have a Cisco 2811 router, running IOS version 15.1(4)M and Call Manager Express 8.6. I have also setup the router to serve out SIP to a few Cisco 9971 SIP phones. I have been able to work out exactly the config required for these phone...
We need to accomplish encrypted RTP (SRTP) between cisco phones running sip and skinny images. We also need to encrypt the singaling traffic between sip/skinny cisco phones and mgcp and h323 gateways.To allow for encryption (not authentication) do w...
Hello all,I have a situation here, with a CUCM 6.0.1, with the following simptoms: 1) Conference with all stations configured (under the same region) to use G711: conferencing is OK;2) Conference with all stations configured (under the same region) t...
