Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi,On voice-port, I have used command caller-id enable, and the system works ok for a time. But few days ago, my system suddenly not show the phone number of call from out side, all are unknow number. I checked on my router, the command is still ther...
I´m trying to install a CUCM 6.1.4 in a MCS7845I3-K9-CMC2 V02, but appears this error message:Critical Error:The hardware you are using is not supported for this product. Installation will now halt.What could be the problem?Thanks
Does CME / CUCME 8.5 support Single Number Reachability (SNR) with a SIP Diversion Header, so that the original calling-id can be presented to the phone that SNR sends the call to?
Hi All,When I am dialing fax number, it is ringing but after 3 rings I get fast busy signal instead of fax tone. Please help to sortout this.Thanks
Hi all,We have a new floor expansion space that needs analog dialtone for at least 5 locations and we wanted to use a VG analog gateway but it looks like our only choices are 4 ports or 24 ports?? Does anyone hear have any other suggestions for this...
"Reroute Remote Destination Calls to Enterprise Number" doesn't want to work in CUCM 8.5.1.11900-21I call remote destination from within the company and it doesn't anchor to the RDP's DN on the desk phone. In other words, it never shows Remote In Use...
Does vic2-2fxs work on cisco2901?I heard that only vic3-2fxs/did is supported on cisco 2900 routers. Is that correct?
I Have 2 CUCM version 8 and i cant get CIsco IP Phones 7911 to register with the CUCM.The minute they upgrade the firmware to 9.0.3S CUCM cant see the phones anymore.Also after that the IP Phones keeps showing "Registering" and "Update TrustList".I h...
My client has a CCME with Unity Express AIM module, CUE version is 7.0. they find that they can not save the save the Call Manager configuration from the WEB interface. (Administration>Control Panel)When they click "Save Configuraiton" from Call ...
Hi,I have EM enabled for all users with FAC code facility for ISD calls......Can i have FAC code to be changed by end user rather than changing everytime by the administrator??
I have a Call Manager Express configured on the 2821 Router.Now that we are upgrading from Call Manager Express to CUCM 8 with Publisher and Subscriber.Now after finishing the initial configuration, I am trying to configure MGCP between the Call Mana...
went from CME to CCM 8.5.Users with multiple lines want their old ability when they are off hook or onhook, when a call comes in they want to lift the handset and press the line the call is coming in on. They do NOT want the phone to auto answer when...
hi! What's the advantage of having 2x PRI ports? Is there any limitation of concurrent call in 1 PRI port? Is it 30 concurrent call or depend on the line that we are subscribing to? What are the type of line available and different between these line...
Is it possible to configure CAC on a Call Manager Express 7.Is there a link to configure this.Best regards
Hello,is it possible, with UC 7.x (CUCM, CUC, CUP, CUCCX, ...) to use multiple LDAP integrations for users?For example: I have 3 offices, everyone with its LDAP server: userA1 and userA2 in LDAP A, user B1 and userB2 in LDAP B, and userC1 and userC2 ...
