Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hello everybody,I have CUCM 8.5 and I want to generate certificate to avoid the annoing screen of internet explorer "Certificate Error" when I singin to the CUCM.I searched in the web about how to install the certificate and I did the following thin...
Hi,I have ATA 186 configured in SCCP mode....I have implemented ISD dialing (for FAX as well) using FAC code..But If i put ATA 186 with FAC code, then it stops sending FAX, where using the same FAC users can dial ISD numbers...any specific thing to b...
HiI`ve been searching for the above answer but came across two - 15 rules and 128 rules - which one is correct?. As with other users I have a situation where I need to translate on a IOS GW 100+ DDI to unique DN`s - thanks
Hello all, Please how can i get (or see) the CDR of a Call Manager 4.2 and do research on calls?Thanks in advance.Best Regards,
Can any one tell me how to disable REFER handling in CCM 8.0.3. Since in one of IOT test cases cisco have to send REFER method for call transfer.
Hi Experts.I am new to ip telphony, and have been usinc Cisco packet tracer in all sort of telephony cenario. When i decided to use the real gear, a cisco 7940 ip phone, a catalyst 3550 and a router, i came accross all sort of issues.My first questio...
I was doing a port scan on my switch and notice that the port for my UCM server has two mac addresses. And there is an IP address associated with each mac. (See macs below.) I went into Cisco Unified Operating System Administration and poked into ...
Hello everyone,I have a problem with CUCM cluster and a SIP trunk. I have 2 Servers in cluster: CCM1 and CCM2. - When I register IP Phone to CCM2, I can make call through SIP trunk.- But when I register IP Phone to CCM1, I can not. I make a call to a...
I am trying to set up a background for my Cisco IP 7942 and 7962 PhonesI have created the Image and edited the list.xml filehow do i tell the Callmanger to start using the new image files?
Hi everyone--got a bit of a strange issue here--upgraded a client from CUCMBE 7.1.5 to 8.5.1 last night. Everything went well except now we can't access any of their phones via the web gui now. Web access is enabled and also http and https enabled....
Hello Dears,I'm trying to block calls to PSTN Network, especially international calls for specific extensions (IP Phones).I'm not able to do it through the after-hours block calls, because of the destination-pattern I'm using under the dial-peer voic...
Can any one tell me how to disable MOH in CCM 8.0.3
I have a customer that has 2811 router with a vwic2-4fxo. There is a route pattern whose destination is a port on that fxo card, the cable of which is twisted directly into a self-amplified speaker series (without a paging interface). I am all but ...
I have an IVR system connected to my voice gateway via PRI. When the IVR system makes a call, there is no calling party number field present in the setup message. All my calls to long distance numbers are failing because the outbound setup message ...
Hello,we have 2 CUCMs: a 4.1(x) and an 8.6(x).We have configured an Inter-Cluster Trunk (Non-Gatekeeper Controlled) between them.It works, but we would like to have BLF on phones registered on CUCM 8.6(x) to monitor phones on CUCM 4.1(x) (we already ...
