IP Telephony and Phones

Hi,I have a CUCM cluster in Germany running 6.1.2.1000-13, the local installed is 6.1.1.2000-1 (german)Have set the default Enterprise parameters to German and the device pool shows German for the network locale.I have an issue though that the user a...

Site ADial-peer voice 10 voipDestination-pattern 9.TSession target ipv4:10.1.1.1 Site BDial-peer voice 100 potsDestination pattern .TPort 2/0:15Scenario:-----------A user in Site A places a call to pstn . This call goes to pstn through Site B. Now ...

Hi All,I am in the initial phase of setting up a 1751V with 2 port FXO and 2 port FXS card to use with Cisco CME. Router has got 32M Flash and 256K PVDM. Please find the attached output of "show version" and "show INV" for your analysis.The issues is...

Dear ,I have a cucm 5.0.4.1000,   I brought 2 7942G phones , but I cannot find the model when I jion it , so I use CCO download ***.sgn, but it always say: md5 wrong, why ? Please help me !

hi guys,we have 22 floor five star hotel in each room i have three phones with same extension and i need to create one user for three of phones with same entension. so that i will have same voice mail.what i need to upload BAT file this scenario.my q...

Hi All,Do you guys know why the Voice mail ports need AAR CSS and Group? Where it comes into the Picture....

while starting the Cisco ip phone series 7906.... getting "Unprovisioned".... after checking from Backend found thatdebugfs SIPXXXXXXXXXXX"Bad magic number in super block while opening file system"*TFTP sever is working finepls any one help in this.....

I wonder if anyone can help. I have a non gatekeeper trunk between CUCM 8.0 and Callmanager 3.3 If we try to do an ad hoc conference  with 2 parties on one site and the 3rd on the other. The call fails to the 3rd party.I have tried setting up MTP on ...

Hi,Have a problem I can't get my head around a solution to:PSTN Connection is a SIP trunk that supports g711ulaw/g711alaw/g729r8/g722Running on UC520 with IOS 15.0(1)XA2 (Call Manager Express)Unity Express 8.0.1Call flow as follows:PSTN SIP Trunk ---...

If I use a UCS C200 server with Emergency Responder 8.5(1) am I required to run ESXi or can I install Emergency Responder directly on the hardware without ESXi? Table 8 Supported UCS Platformshttp://www.cisco.com/en/US/products/sw/voicesw/ps842/prod...

I have an ASA 5505 that I'm trying ti use to get a Phone Proxy running.  At the moment, the phone is plugged into a switch that is then plugged into the outside interface on the ASA.  I've tried a couple of different configurations that I saw in a co...

Referring to the topology in the attached diagramI would like to know how it is possible to send a fax from Site B (Branch) using the PSTN line of Site A (Head Office) over the WANWhat are the commands and configurationI can make phone calls over the...

Hi I am having hard time finding accredited school that offers CCVP ... for me to take the classes the institution have to be accredited schools. This one of the requirement from my employer..if anyone knows of any school please let me know.Thanks

Hi, I would like to know is it possible Number Spoofing with Cisco Router through E1 or T1 some other way.. Please let me know is there any way we can do it. Regards,Sunish