IP Telephony and Phones

Hello there,I have 2901 router with 2fxo ports and 5 cisco ip phones(extensions: 1101 to1105) in my house. I made the configuration required to make all the phones work and each phone can dial other phones extensions successfully (all internally so f...

Hi,I am having issues with FXO not disconnecting immediately after Outside caller hangs the line before internal extension answers (2921 (IOS 15.1(3)T, CME 8.1). Also, when outside caller establishes call the IP phone will not display caller-id (it w...

Guys,I have a challege to use only one DID/dn for receiving fax as well as voice. i was searching for fax2email solutions which actually requires separate DID/dn for fax & voice.I was told by one fax2email software vednor that CUCM has capability to ...

Hi, I facing a problem in Mobile Connect. I am calling Phone A from Phone B. Simulataneously Phone C (Mobile Phone )configured as a remote phone rings. I pick up the Mobile Phone and answer the call. At this point of time i can able to see the Red Le...

Hi, I need help with programming on a CUCM 6.1.2 and I do not know if this is possible. However I have a 2000 int device that I have to configure as follows: must have the ability to make internal and external calls, but the device can be called only...

Hi GuysI am just wondering if I can buy or get spare pap2 shell/case along with a label for mac address. Because the reason why I am asking is because I bought a used pap2 from ebay and its so scratched up on the front and back and its missing a labe...

Im new to Unity and I need to make sure that our holiday recording kicks in for the next week of the holidays.  I went under System Call Handlers and created a new item and called it "Holidays 2010" and then recorded my message" Now what?  Normally i...

HiWe have  CUCM upgrade planned from 6.X to 8.X.Currently the CUCM 6.X has users with Extension Mobility. Users are logged on to the IP Phones (7942G) and there is no max login time / auto logout configured on the CUCM, that is, users never get autom...

Hi All,I am using CUCM 7.1.5.3 with SIP 9971 IP Phones when user enters forced authorization code on 9971 series phones it displayed in clear text insted of **.so i need to upgrade phone load for that? or need to configure Phone with SCCP?Thank You!!

My question is how do I manipulate the voice router to use a specific set of incoming/outgoing dial-peers when a call is received to a specific DN.  For example, I want the voice router to using dial-peer 1111 to process an incoming call to x0752 but...

Okay, so I've almost completed my first CUCME instal and the customer has requested non alphanumeric logins for extension mobility. For the life of me I can't find any documentation noting how this can be done.So can it? And, if so, how?Nigel