IP Telephony and Phones

Showing results for 
Search instead for 
Did you mean: 

Forum Posts

CUCM 7.1(2) recovery disk

I am trying to make a disk image of our call manager 7.1(2) server before running the 7.1(3) patch and I have a disk error or a  bad sector on it.  I was wondering if there is a disk check like option on the recovery disc?  I had another server crash...

cmoranNSNF by Beginner
  • 3 replies
  • 0 Helpful votes

SIP Trunk Tone On Hold

CUCM Version: 6.1(3b)sr1CUBE IOS Version: 12.3(20)T2I am trying to configure Tone On Hold (ToH) on a SIP trunk. The initial objective was to disable MoH completely on the system and enable ToH to play a single audio tone when a call is placed on hol...

MOH from router's Flash

Dear Voipers I have the follwoing design:1 CCM installed (IP and One gateway configured for SRST (IP on the head office. I need to configure the following: When some one is held on the phone, he should listen to MOH from the...

CME w/ VG224

I'd like to deploy a VG224 w/ CME v7 via H323, as opposed to SCCP so the analog ports will not subtract from the supported phone count that the ISR will support.According to everything I can find, if the analog set requires any features other than th...

alubenow by Beginner
  • 5 replies
  • 0 Helpful votes