IP Telephony and Phones

Hi!I discovered yesterday a problem with Extension mobility and CiscoTSP. The problem is this.  When a Tapi app checks the devices which are connected in this moment, the app asks through CiscoTSP to the Call Manager the status and events of these de...

Hi all,Can the TSP/TAPI software (e.g. TSP-SingleLine-2.2.0.5.exe) for CUCME be installend on a 64bit XP workstation?Thanks,Norbert

I have a site running 7941 phones in CME 7.0.  Our site is reporting that when they resume a called placed on Hold, the phone will go blank after 3-4 seconds.  The phone will then come back up (Does not register like a complete hard boot).  The call ...

All,In my call manager configuration, I have the following setup: Cisco Voice Mail Port, ports name CiscoUM1-VI1 to CiscoUM1-VI16 have calling search space 440_National_CSS attached to them. Voice Mail Pilots configuration, I have Voice Mail Pilot Nu...

I have Fax Server (Brooktrout SR140) connected via SIP trunk to a CUCM.CUCM is connected with a SIP trunk to a 2821 cube which has also a SIP trunk connectivity to PSTN.Find attached a network diagram.SR140 supports FoIP through T.38 fax relay only. ...

HI,I have a CME installed on a router with NO pri card. I have this connected to a AS5300 GW, which is currently working for voip on another PBX. I have configured the CME and can make outbound calls ok, but i cannot get the main number to connect to...

Anyone have an issue with the CS55 headset hanging off a 7960? For some reason the incoming call alert beep in the headset quit working. It works on other phones with headsets and the CME config is identical on all the phones. Thanks in advance.

Hi,This is a question about Cisco IOS upgrades and is no really related to IPT so apologies for that - there is no forum for these topics so I thought I would post it here due to the number of knowledgeable guys that hang out here.Enough flattery, sc...

Is it possible to exempt an end user from showing up in the directory?  We are syncing with LDAP and adminstrative folks have two AD accounts, so they are showing up in the directory twice.  Just wondering if there is a way to avoid this. 

Hello all,I'm hoping someone can help my save a 7961 from the old phone heaven in the sky!Problem is, I tried to perform a factory defaults reset using the steps found here -->http://www.cisco.com/en/US/products/hw/phones/ps379/products_tech_note0918...

Hello.We have a CallManager 7.1.3.32900-4 with several IP Phones 6921 with 8.5(3) firmware.Our problem is the following: it seems that the PC port is unstable; sometimes, when we receive a phone call on a 6921, the device attached to the PC port goes...

Hi Guys,         I am looking at upgrading Cisco presence version 6.0.3 for one of my customer. I need someone to point to the right direction where i can find document on1) What features i will loose or get after upgrade to 7.0x version.2) What is t...

Hi guys...I just wondering... do I need to use the same cor name and cor list for each sites for interconnected topology using Fa and Se (ospf/eigrp apply)?for example,SiteA(CME)--------SiteB(CME)--------SiteC(CME)|                  fa|Se|SiteD(CME)-...