Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I have a customer that I'm installing a UC540 for - replacing an Avaya Partner system. They currently use 2-digit dialing and they don't want to change that.I'm using CCA 2.2.2 and going through the Telephony Setup Wizard. When I get to the "Define I...
Hi,Quick one.......Can someone tell me where you can (or if you can) change the time that the CUCM Admin page takes to timeout from inactivity & make you re-login again?CheersRussell
Hello All,Do you know a way to recover/reset the CUCM Security Password without knowinng the actual one? I have lost it.Thanks
HiI recently installed Cisco unified communication manager publisher and subscriber i added the second server as subscriber but my subscriber ip address is not showing in Ciscu unified CM Group as a redundant server when i logged into subscriber wit...
hi,am looking for a Tokyo locale files for my Unity Express. can someone helpme where can i find and which version i should usedetails of my unity expressInstalled Packages: Installer (Installer application) 2.2.1 Thirdparty (Service Engine Thirdpart...
I have a fax hooked up an ATA186 that would send and receive faxes without a problem. Today the device would not receive faxes but would send them. When I hooked up an analog telephone to the ATA it rings just fine, but when you connect the ATA to th...
What kind of integration is available between Cisco Call Managerand Microsoft Active Directory ?We need to automated synchronization of phone number from CCM to AD, so the phone numbers in ADincluding outlook address book will remain updated instead ...
We have a Cisco 2811 at a remote site that is connected to our hub via a VPN. We are interested in terminating a service provider SIP trunk onto this 2811 using CUBE so phones at the remote site can use the SIP trunk on the 2811 as their gateway. T...
Hello,i would like to minimize the Ip-Communicator, when starting it, so that it do only see the task icon. Changing the startup typ in the parameters of the Desktop-Link does not affect.After changing the parameters on the IP Communicator(Hide on mi...
Hi all, I am new to SIP and Im trying to figure some things out. Id like to ask if anyone has a topology they might be willing to share so that I can try to understand the SIP components and what I might need to do on a particular project I have. I...
I have been tasked with gathering the number of registered phones in two different clusters. One cluster is a 4x the other is a 6x. Instead of counting them I was wondering if there is another way to go about finding this number. Thanks!
I am a student doing my honours dissertation and I am trying to set up a secure voip connection using secure RTP, I have attached the configuration file and basic network diagram.I am using IP phones using Cisco Call Manager express. When setup wi...
HiI recently setup IP Telephony setup for my company with CUCM 7.I Got a request from my staff that they want to dial Internal 4 digit without pressing Dial Soft key.They were using before Nortel BCM and they just press the 4 digit internal extension...
What is the best place (gateway or CUCM) to perform the translations for called and calling (inbound/outbound) numbers when I have Call Manager 7 with a ISR?.
Hi,One of our customers needs us to busy out there PRI's while they install voice firewalls. There running CUCM 4.1 and the gateways are all MGCP. I found the document below and I have a couple questions about the gateway reboot in step 6. Can I d...
