IP Telephony and Phones

Hello, Can anyone tell me how to configure snmp String on CUCM thorugh CLI.Thanks

hey guys..is it possible for us to disable the call history(dialed/recieved/missed) on a particular extension???

We have a AS5350 or AS5400 How can see the results of "Show controller E1" stats and config on SNMP querys?

I have been looking for sip files, but up to now I can just find SCCP.SIP11.8-2-1S.loads*term06.default.loadsterm11.default.loadsapps11.8-0-2-55.sbncnu11.8-2-0-55.sbncvm11sip.8-2-0-55.sbndsp11.8-2-0-55.sbnjar11sip.8-0-2-25.sbn

Hi,Does any body know how to setup 7965 with SIP firmware to use iLBC 30ms frame. Something like IOS dial-peer command "codec ilbc mode 30" I have media gateway that supports only 30ms frame, phone works 50% of them with it. I could hear the normal ...

Do you need extra DSP's on a voice gateway to add a VG202 or 204 to a voice network?

Hi,We are implementing a CUCM SIP trunk to a third party system. This system sends SIP INFO Msgs for DTMF tones as described in RFC2976.According to the CUCM 7 data sheet it supports RFC2976, but in the SRND guide it states that it only supports KPML...

Hi All, I have set up a sip trunk to a isp via CUBE h323 gateway and call manager 5.1.3 all voice call are fine but DMTF tones are not working correctly. Inbound tones work to a IVR but not to phone and outbound tones don't work at all.

sorry for all the double posts. thank the apache error that is killing me.So help me understand this call flow.I have an analog line on an FXO coming in with a connection plar opx statement.The call comes in, hits the port and heads off to the plar e...

Hi all, I cannot find some easy way how to solve this problem. We have hunt pilot and under him five DNs. But when you call hunt pilot number from CCM internal number, you see first member of line group (within this hunt pilot) alerting name on your ...

I have a Unity box on Windows 2000 server and an Exchange message store. Is it safe for me to run the Windows Disk Cleanup utility, "Old File" compression and all?

Today we have Cisco UCM 6 configured with a SIP trunk to Exchange 2007 (for Unified Messaging).We want to setup a Secure SIP Trunk, but have no idea on how to go about doing this.Has anyone setup a Secure SIP Trunk and got it working?How would I setu...

Hi All, I am trying to troubleshoot IP communicator and enable logging. but I don't know where to read that log file. any suggestion would be very appreciated. thanksAlex