Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
i have a cisco 2821 and i am working on ccie voice. i am having a problem accessing the voice mail system. i have set up a piolt number but when i hit the messages button on my phones i does nothing. can anyone help with this?thanks
Hi all,Is it possible to enable cdp and snmp on Cisco IP Phones ?Regards
Hi,I am in the process of adding a 7965 and 7916 onto my CUCM v 6.1.1.2000-3.I only have 2 7965's 1xSCCP and 1xSIP.SCCP to be able to to hold a 7916 but I cannot see on the device settings a option for 7916.I have uploaded the latest firmware for bot...
Hello,I have a quescom 200 gsm Gateway and I want to use it with my uc520.I would like to have call redirected to Quescom if I dial a number with a prefix of 9.The dial peer correctly forward the call to the quescom gateway but the call fails due to ...
HiI want to connect CP-7925G wireless ip-phones to a callmanager version 4.2.3. According the documentation is the CP-7925G supported in this CM version. I installed the newest device-package ciscocm.4-2-3-DevPack-54. But the cp-7925G ist not availab...
Has anyone ever run into a situation where a PRI is sending a "#" at the end of a number that is being passed to the telco. I have a situation where two of my dial-peers are forwarding a "#" after the end of the string that I appear to be forwarding...
In my 2821 voice router some of the calls get disconnected after ringing once in an ip phone( fxo and mgcp)voice experts please suggest some troubleshooting steps
Hi all,I have a single FXO port. How could I do so that it will be possible to reach directly each ip phone registred with a CCME ( or SRST).Thanks,
How would I go about mapping a line to a button in CME? I want to make sure that when I user presses a button they get a specific line. Thanks in advance for the help,Steve
how i monitor who has logged in call manager 6.0 webinterface. because i need to monitor any illegal user logsin into the ccm webinterface...
Hi,I have CCM in release 4.2On E1 qsig link between a CISCO 2851 and IP PBX ALCATEL, some ITs goes out-of service.I only seen this status in RTMT (see in screen shoot in attach)Do you kwon why this channel goes in out-of service status??When I make a...
Hi,Is CUCM 7.0(1) available for pruchase? If so then I would apparetiate any help for the product version number and hardware compatiblity matrix. I have been informed that it was released last week but cannot find any information. Only thing I can f...
Is there a direct web link to the Corporate Directory from UCM 6.x that DOESN'T require a login? The one we used for 4.x was something like http://<cm ip>/ccmuser/directory.aspThanks in advance.
folks, I have 2 ccme's accross the wan and i want to limit only 2 simultaneous calls between them, how do i go it?
Does anybody know, who uses Mac OS X, if there is a good TAPI apps for Mac OS X thatworks with CME?Thank you!
