Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I have UCM 6.0 and have added a 4-Port FXS/DID card to a 1760 Router running IOS 12.3(14)T4. I have 4 Analog Trunk lines running into the card that carry our 20 DID block.I have successfully registered the FXS card with UCM, but when I place a call o...
Hi,we wanted to add a CME in our CU Operations Manager. We added it with its management IP, but because this IP is different than the IP for managing the Call Manager, it appears as unreachable in the CUOM.Of course, there is a firewall between the C...
how do i change the MOH for every phone on the CCM6.1.2.in 5.1.3 i could do that on the device pool, but that option is not available in 6.1.2please help
hi, i am working with ucmbe (bussiness edition), and i want to change the laguage of the voice mail, how is the procedure ? thanks
Chaps, I have 7 sites, all serviced via a centralised CM 4 cluster. Each site uses a 4 digit translation pattern where I add the full national dial code under the prefix digits section so that all calls are routed out via the local voip gateway over ...
I have uploaded the overall topology to the SRST Scenario.ppt docwe currently have two routers per branch to provide redundancy for WAN connection on the major sites and we are looking to provide the PSTN connections to both routers through PRIs.DHCP...
Hello,We have set up a simple B-ACD queue script for one of our customers and it's mostly working right, but the option to leave a message (aa-hunt2) isn't. When option 2 is pressed, we hear the MOH audio stream instead of going to that extension's ...
Looking at my Config File (GW 5400), I found:interface Group-Async0 ip unnumbered FastEthernet0/0 encapsulation ppp ip tcp header-compression no ip mroute-cache async mode interactive peer default ip address pool dialin_pool ppp max-bad-auth 2 ppp au...
In CUCM6, is it possible to do send a call towards a route pattern (H.323) and, if the call is busy or the gateway is down, the call should go to a directory number.thanks in advance!
Hi Friends, If anyone has suggestions, I would appreciate your help. I have configured an MGCP gateway with an FXS port for a Polycom conferencing station. Everything is working as expected except for 1 issue. If the Polycom initiates a call and ...
Hello,Am experiencing a problem with a Callmanager Express that i recently deployed.The problem is after a call is made,the FXO take a while to terminate the call-it shows the call as being active for some time though the call has long been completed...
I am looking for feedback on using Microsoft UM as the voice mail hanging off a Cisco CM cluster.Some questions:First, who's using Microsoft UM and what has the experience been?What are your mailbox ID's - do they match the format of your dial plan o...
Hello, I need the Russia - Russian and US - English localisation files forCallManager Express 7.0.0.1.Can you anyone tell me where to download them ? Many THanks,Dirk
I have a CME 4.2 with liksys phone registered, I can make calls between them,I can make calls to PSTN by means of E1 link, but now I'm carrying out test using a SIP provider but I can't even communicate with SIP proxy. I have already set dial-peer, ...
I have 2 CUPC users. When 1 of them updates the contact list it happens immediately. When the other one does it, they have to logout/login. If I login on a different PC, then problem still happens so appears to follow the CUPC user. I can't see any d...
