IP Telephony and Phones

Hello,I need some one to help me on how to configure my MGCP gateway to receive calls from the PSTN. i can dial out to the PSTN perfecctly well.i want to the call to go to a receptionisyt desk who route it to the desired extension.i use call manager ...

Hi,Presently the hardware details of the CCM 3.3 is as follows: RAM-512HDD-40 G.BCPU- Compaq Proliant DL 320 server1000 megahertz Intel Pentium IIIPlease let me know whether the same configuaration canbe used for CCM 4.1?TIA

I tried to use 'User System Transfer' of Unity connection2.x for those employees outside of the office to use company's calling number make outbound call.whereas, afetr user entered his ID and passwd and make outbound call, the calling number shows V...

Hi,We are using Cisco call manger 4.2 for IP telephony. Now we are also going to install Alcatel Lucent EPBX (OMNI PCX) in our office. Now my question: is it possible to configure Cisco call manger so that Cisco IP phone users can call to EPBX (Alcat...

Hi I have a problem with Extention Mobility, the service Cisco Extension Mobility this configuted Maximum Login Time in 8:00 but the ip phones to make logoff after 5 minutes. The choice Enforce Maximum Login Time is true. Any solution?Thank you

Hello,I would like to create a conference using calls on 2 different lines on a Cisco IP phone 7931.I followed the procedure here below that I found in the "Cisco Unified IP Phone 7931G Phone Guide for Cisco Unified Communications Manager 6.1(SCCP)" ...

Hi everybody,I have a problem to dial number with Click 'n Dial.I use the application with a Mobility Device Profil and not a Fixed profil and has tick the CTI control for the user and has the Extension Mobility activate for the Cisco phone 7960.I c...

I guess I know the answer to this, but was wondering if there had been any developments in CUCM6.If a user picks up a call on another extension using call pickup, the original extension logs a missed call (even though this call has been answered), is...

Hi,I have 3 out of 24 VG224 ports stuck in off-hook status. I resetted the port 7 main gateway (mgcp). Version of ios is as belowvg224 Software (vg224-I6S-M), Version 12.4(5b), RELEASE SOFTWARE (fc2).I usually experience this problem on other VG224 a...

I`ve just installed 6.0 CUCM and have 50 license for handsets and a node license being shown , I`ve created 3 x devices and the number of units have decreased in the reporter but the phones are not registered. Are these licenses real or do I need to...

I need to mask the outgoing number ID for a particular DN and I need to be able to do it from within call manager 4.2 as opposed to on the Gateway! How do I go about doing this? Anyone? : D

CME in SRST mode yields up/up dial-peers for the ephone DNs. This results in no inbound calls. Have the exact same hardware/IOS/config on another site and it works properly. Baffles me. Anyone run into this before?CME 4.1IOS 124-15No ephone's registe...