IP Telephony and Phones

Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Hi,I've got a new UC520 here, When I type voice hunt-group 1 parallel, list, then enter 2 DN numbers, it whinges about number xx not being a DN number.It is a DN number as i can see it and it works... Is this trying to use the SIP parallel hunt group...

davieshuw by Beginner
  • 1 replies
  • 0 Helpful votes

Hi I'm trying a scenario of 2 GW's and a GK Am able to register 1 GW without any issues the other one is not registering tried no gateway/gateway and debug h225 asn1 & debug ras doesnt gives any output, Able to ping from source IP's Attached is the c...

Hi,I`ve 2 GKs and a group of 10 GWs that I'm cofiguring to register against the GKs.I've configured ok 3 GWs, but when I configure the fourth it doesn't register. The configuration is the same on this GW.This is the configuration for a GW that is reg...

Hi all dear friends, I'm having a problem with my CCM, sometimes the users cannot obtain the dial tone and the use of the CPU is 100%. The RAM has 1.5GB and the proccessor is XEON 3.0 GHZ.Anyone can give a tip to resolve this issue.Thanks a lotDavid

david-lima by Enthusiast
  • 4 replies
  • 0 Helpful votes

Hi all, I am currently running CME V 12.4(11)XW7 on a UC 500 and keep having random phones drop into the logged out of hunt group state. The Hlog key is disabled. Everything is working as expected apart from this and it is ver frustrating. I hav...