Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I have tried this before about 5 months ago and found the same issue. I had hoped that by now Cisco would have fixed this issue.I have a 3825 currently running 12.3(11r)T2 as our voice gateway that has two PRI's terminated into it for PSTN access. ...
Hello,What's the syntax I should be using for the 'Remote File Path' when uploaded my tar file. I'm using 3CDaemon with my tar file in C:Many thanks in advance.Michael
All of our IP Phones are DHCP enabled. Today we setup the DHCP server in our environment and moved the DHCP scope i.e range of IP addresses from old server onto the new one. All IP phones automatically got registered to this new DHCP server. My quest...
I have a 7961 phone that is used by a receptionist and I have setup the buttons like this:1- Ext 2012- PSTN Line 13- PSTN Line 24- PSTN Line 3Two issues with this setup. Inbound calls from the PSTN goto the PSTN line buttons on not Ext 201. Therefo...
Anyone know whether using dual-line will limit the max directory that is available to use in SRST?
Since Cisco have changed the download website, I can no longer find the readme release notes that used to accompany a CallManager patch/SR. All it does is refer you to a link that contains the baselines release notes, which aren't the correct ones. W...
Can I use Cisco Unified Personal Communicator as Instant Messanger feature? What equipment should I use? Is it enough CCM? Or I should buy some additional devices?
Hello there,What is the Cisco recommendation for setting port speed on the servers.I know on older servers that were 100 meg nic cards, you hard coded as 100meg full duplex on the call manager as well as the switchportwhat is the official stance on t...
Hi, I am having a problem with a few extension numbers, they have all been working before, since yesterday, an extension number 7163, cannot receive calls, Internally when 7163 is dialled, it rings twice then cuts the call, when dialling from an exte...
Hi!I've configured speed dials on an expansion module. It worked fine.Some days later I've tried to change one entrance. After the reset no speed lines appeared on the module. After some troubleshooting with no success I've configured a speed dial on...
Hi,Please can some one explain to me how to calculate % of overall b/w saved by cRTP for G.729 voip call packetsized at 50pps.Regards,
Hi,I am a new user using CCM 4.3.I have problem getting DID calls to IP phone, from PSTN and get a busy tone instead.e.g. the DID number is 65902100 and the line number for phone is 2120, so I am doing a translation in voice gw from 65902100 to 2100,...
Hi guys,I faced some issue related in integrating the UC with OCS Mediation Server.The topology is like below;CIPC <==> UC <==> SIP TRUNK <==> MEDIATION <==> OCS <==> SIP PhoneAre there any idea to make the call from the SIP Phone to CIPC can communi...
With CUCM 6.0, can it be configured where for inbound PSTN call, it will have one ringtone, whereas for inbound internal call, it will have another ringtone.Is this possible??
We have Unity 5.0.I am trying to set up a Call handler based on 2 new schedules I created.The First schedule covers 8am-3pm and second schedule covers 3pm and later.I am trying to point an extension 2222 to ring another extension 1000 during the seco...
