Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi Guys, Our Customer have any sites and the sites with FXO the Fax work. There is a site that we have E1 R2 the fax don't work, appear the message "communication error". Ask, there is any specific configuration in the Gateway or ATA for the fax work...
Greeting's, I am trying to figure out what digits are being passed to the ipccx server? The following is taking place... I am using callhandlers in Unity for my AA greeting's and when the caller presses a menu key from a callhandler with the ext of ...
Wanting to install Unity 5.x in same AD domain as 4.x is. Will the schema extensions done by 5.x, have any effect on the 4.x installation?
Hi everybody, we have a problem with the voice mail ports configuration in the integration of CUCM6.0 with Unity Connection 2.0 , it means when an internal number leaves a message to another, this can not access your mailbox, when the pilot call numb...
Hi everybody, i have a problem when i try to forwall calls from my ip phone, i only forward calls for internal users but not for cellphones or external numbers???
Having an issue getting layer 2 between Cisco 2811 and IP Alliance sollution.Layer 2 keeps bouncing.Posting config. from Cisco 2811.controller E1 0/0/0 pri-group timeslots 1-31 service mgcp description DID Range(s): xxxx;xxxx;xxxxinterface Serial0/0/...
Dear Friends. I want to know the use of DOHproptest utility in UNITY. what are uses of tool. pls explain.RegardsGem
Is there a way to get intercom like functionaliy without having two use to DNs per phone? Seems like having two DNs and two buttons is wasteful and if I recall most tradition PBX/key systems can do this using just the primary extension.Thanks,Diego
When we receive a call on the PRI GW, the first character is missing on the phone display. This is working fine in SRST. I have set the "Send Extra Leading Character in Display IE" parameter on call manager and I have the first character but extra fu...
Hi,Unable to see voice-port command in 3845 router.PVDM2-64 modules have been installed and displayed in "sh diag"NM-1CE1T1-PRI has been configured and the "isdn status" is also up.Any suggestions..
Hi,I am trying to use TSP for outlook with ccm 6.1.2. However I get the erros below.I have done the following:1.Installed TSP plugin and tapi wave driver2.configure TFTP IP under TSP config3. Restarted CTI manager4. Ensure owner user id is set for u...
6.x Upgrade When upgrading to a version that requires a specific previous version do you have to upgrade the inactive partition to the required previous version first?Case in point:Partition VersionsActive Version 6.1.2.1000-13Inactive Version 6.1.1...
I have an 30 channel isdn connection and also an FXO card connection to PSTN on a 2801 gateway. because 2 companies are sharing an callmanager express gateway,I need to seperate users so that 1 company can only dial out of an FXO port and the other c...
I am ordering a PRI to use on my UC520. The vendor has given me a form to fill out with a few questions that I am not sure how to answer. Considering I am using a UC520, what should I select for:1) ISDN Version: Nat1/Nat2/NT DMS 100/5ESS2) Hunting:...
Hi,Further to previous conversations, I have tonight upgraded our customer's CME to 4.3.0.0 in order that they can make use of a newly purchsed 7937 handset. Having followed the instructions posted within other conversations, I believe that the confi...
