IP Telephony and Phones

Hi dear,I have two Unified CM 6.0 7835 appliance - one publisher and one subscriber..should i need to activate both server (publisher & Subscriber) or activiting only the publisher will be enough.Info: I received two different licenses.Thanks to help...

Hi dear,During my requesting to activate the second node of the existing CM6.0 installation (one publisher and one subscriber)...i put the wrong MAC address and therefore i received the wrong filing...What could i do to correct and put the correct MA...

Does anyone have ompability matrix spread sheet for UC products. I looked at the tool on cisco.com, but could not find what I am looking for. Actually, I have to upgrade clients environment to latest version respectively.They have, Call Manager, Unit...

Hi, if I am setting up an ISDN30 PRI on CME in the UK (BT) and we have purchased 6 channels, does the D channel need to be included in the config i.e. pri-group timeslots 1-7Thanks.

Hello, I was in the need to set an inflexible business schedule *and* proper call management with queues, for which I was using CME's B-ACD. I tried to use a co-resident CUE for that, but ran into problems (related to the method used by CUE to transf...

HiMy customer have a configuration down. Why the numbers are match on dial-peer 1?881327340508214596326989256789541And why the number are match on dial-peer 2?408220003561697864589696I think that all the numbers are match in dial-peer 1 because it`s ...

I have MD110 as pbx. the MD has E1 link from telco to provide outside calls.I defined in my VG "9" for going out .when a user dial 9 two problem occures:1) the user hears some kind of noises!!2)the user can not here dial toneplease help

Hi,we can restrict different kind of calls using COR list on CME but is it possible that somehow phone not allow specific calls unless i enter a secret code?Looking forward solution for it.Best RegardsRameez

Do we need to configure anything to accept a call from an another system, may be another Call Manager. We do not need to call them but they will forward an incoming call to their system to our system to a number. thx

Hi, I'm implementing a Callmanager express for a client and i'm experiencing a problem. I configured speed dial on a 7961 IP phone. The speed dial shows agains some of the botton on the phone and does not show on other botton. Despite the same comman...

hi everyone...iam implementing ccm5.1 and i have this particular request from the customer..during office time i need managers calls to be routed automatically to secretary and during non office time it has to ring at the managers extension itself..t...

Hello all,I am planing to integrate an Avaya G3 V12 with a CCM 5.1. I am thinking of using either:1) A SIP trunk btw Avaya G3 and CCM 5.1 or2) a Cisco 2851 (CME) Gatway with PRIMy question is how the licencing is going to work. Do I need to buy any l...

We have a new phone system almost ready to test.We have an edge router that is connecting to Verizon's PIP network and will pass the traffic to our internal network on the same router's ethernet interface.The IP to IP gateway router will actually be ...