IP Telephony and Phones

I have two 7825-H3's out of the box that don't have RAID configured or anything. These will be part of a new 6.1 cluster that we will be upgrading from 4.2, so the 6.1 disks came separately.Whenever I try to load from the disk I get the following Di...

Hi all. I have a question that Im trying to see if I can do or not. I have a customer with a CME (and another with CallManager) that has a remote site. Customer has a vpn back into the main site, and they have their IP Phone that goes across the v...

Hi,please find attached two methodes of enabling QOS on CUE. they are conflicting or at least they are talking about the same thing.which one is the right setup.please adviceGood day

i need to hide internal numbers on the ccm, there should be only the name presented on internal calls but not the number from the phone which is calling.It is used for the managers "private number"Best RegardsThomas

Has anyone carried out an upgrade from CCM 4.1(3) sr2 release to 5.1(3) does the upgrade CD come with a PAK key for license generation and if it does how can i re-generate it if the same has been lost by me

Hi,We have a Cisco2811 with NM-16ESW with PPWR-DCARD-16ESW, the card is working fine with PCs and Servers connected to it, however when we connect the IP Phone, it is unable to powerup the IP Phone. Is there any specific configuration to enable the P...

Can I add VG 224 ports through BAT? If yes let me know brief procedure.I heard it is possible in VG248.ThanksKMS

How can I auto register VG224 ports with CCM. I tried below but did not work. Manual port registration works. 1. System >> Cisco Unified CCM >> uncheck “auto registration disable on ...” .Configure auto registration range and partition. Clicked u...

We want to change the way the system is recording dropped calls. We want to change the system to the following, if possible: any call that is dropped before 15 seconds is not recorded as a dropped call. I believe the default is 5 seconds. Is there a ...