Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi all,Is it possible to display a name against a Hunt Group so users know what number was dialled? ie Main Line displays "Main Line"CheersRich
Hi,I am unable to leave a voice message. When the subscriber phone is busy it enters the voice mail box of the subscriber and prompts me to leave the message after the tone. Once after i leave the message it prompts me to dial 1 to send the message ,...
Hi Pro.i have a CME router.the number we are receiving in directory without 00 in front and the user cannot dial from directory.i have to create translation rule incoming,so that it changes all the incoming international number with 00 in front.thxx
The docs make it look too easy: 'utils ntp config' seems like it should change the NTP references, but all it does is give me the following status:"This node is configured to synchronize with its hardware clock".Is there any way to set the server up ...
Hi,I have a 7940 SIP phone, the network config is locked and I am unable to unlock it.I have tried1. "xx#": this did not work2. I went into "Unlock Config", but I do not know the password, I tried the default "cisco" and it did not work.3. I tried to...
Hi!I have defined Meet-Me number. How can I restrict access to this number (calls from PSTN), in the way that only specific external telephone number can access this pattern?Is this possible?thx
HiDoes AIM-VOICE-30 in 3725 WIC slot support? I will not use any NM or EVM, just the integrate WIC slots2 qty VIC-2BRI-S/T-TEand1 qty VIC-4FXS/DIDThe following links mention general support but not btwn all threehttp://www.cisco.com/en/US/prod/collat...
Good DayI have a MPE on a MCS server that i have launched in my lab.I have made access to the external meeting page thru a ASA 5510 with a external dns name.On internal maint interface I have only ip. But Im unable to get to the admin page for creati...
Hi, I would like to have the basic configurations for MGCP on 2851 Router in Saudi Arabia as the CP-Tone will be Brazil as the SA CP-Tone does not disconnect the signal.Thanks
Does anybody know how to enable the second NIC on MCS7823H2 server with Callmanager 6.0 loaded? Thanks!
Hello,I use two Call Manager 5.1.3 (Publisher and subscriber).The Publisher has crashed, and I had to re-install it.So I havo to re-upload the license of the publisher and the subscriber.After that i've added the subscriber license, i've added th ser...
Hi I have configured a Call manager with about 50 IP phones connected to it. for the same I need to configure call barge. could anyone guide me how to configure Call Barge with CCM.thanks and rgdsRajesh
What is the latest compatible device pack for CCM 4.0(2a)sr2c that would also be compatible with SRST 3.3?We found out that the 7961/7941's require at least ".... 7-0-2sr2...".
Is it possible to have multiple prefix options in a dial-peer? If so, can someone explain the logic on how correct prefix would be selected. In studying for cert I came accross below dial-peer. Please help me make sense of logic on how this would ...
Where stores the car databse in the ccm 4.2(1) ?, is the same database that the one that uses the ccm ?Regards
