IP Telephony and Phones

Hi,Does anyone know if the 1841 supports the VWIC-1MFT-E1 module for basic QSIG functionality because the 1841 product documentation indicates data only.VWIC-1MFT-E1 1-port RJ-48 multiflex trunk-E1 v (data only)I am not sure what (data only) means ?A...

i have configured the PRI it has 1-16 channels and i have bind it to CCMi am not able to make calls i am attaching config also.

We have installed Communications Manager (CallManager) 6.01a for the State Legislature. The Senate members have analog phones inside their podiums. These phones are configured so that if they lift the handset a specified line on their Secretaries ...

hello everyone,i have CME with 4 analog lines. i have caller id enabled from the provider but not able to get it on the IPphones.iam usin the followin version of IOS:(C2801-ADVENTERPRISEK9-M), Version 12.4(15)T1iam also adding config of one of the vo...

Hi, I have following problem :If I dial to a busy destination in PSTN there is no entry in the placed calls directory.Design:CUCM 6.0.1 with ES-2124-1 , C2851 Gateway (IOS 12.4.15T1) with 3x E1 configured with MGCP/QSIG (ISO) behind PBX (Siemens HiP...

hi, looking for info on LDAP --> ADI have integrated LDAP to W2K3 AD for the users.question 1. how does one bat process the telephone number in AD, so it can push it to Callmanager. If your answer is csvde, please provide an example.question 2.how ...

When setting up a system that includes both wired and wireless phones, should one put the wired and wireless phones on the same VLAN or create separate VLANS for each type of phone? What are the pros and cons of one VLAN vs. two?Thanks,Diego

Just a quick question, after just having rolled out our new CCM system, we are having a small call quality issue with the call dropping out then fading back in rather quickly. Just wondering if configuring autoqos on our L2 switches will help with t...

Has anyone been able to configure the C2821 gateway router to allow 911 callback through the PRI line successfully? 911 outbound call through the PRI is fine, but we need to be able to have the 911 operator be able to call us back if needed from the ...

Dear All,I have a problem with my voice port, the green light always on and off, when this problem happened we cannot call through this voice port.Please advice me, if someone have any idea.Best Regards;Boly

Hi all,I'm trying to send a call through a T1 PRI trunk from my 6608 --> CUCM --> router.What I'm trying to do is this for example:dial--> 1234 CUCM send to trunk --> routerusing this command:debug voip dialpeer all Currently I get no log of any mat...

Hello,We have CM 4.2 and an I3 server (SIP) for ACD and are having issues getting DTMF tones out our CMM blades to outside phones. When we dial them and the other end asks for an extension we are unable to enter any numbers from our phones. This only...

Where can I download the Attendant Console for CCM 6.0.1Did not see that it was available at the Cisco Site.

I have a problem when receiving incoming call. The router strips the leftmost digit (0) off and present only the last 10 digits. for example when caller (0123465245) calls, only 123465245 appears on the cisco IP phone. Can somebody advice me on what ...