IP Telephony and Phones

I have configured some manager each one with one assistant associated I worked fine. Now one the manager's ip phone is not working fine (I am doing a rma request) and I have changed the fault ip phone with a new one (both of then are 7961), I have as...

When a cisco phone boots, does it:First get an IP address from dhcp server (if configured for DHCP)?The mac shows up first in data vlan, then in voice. Why in the data vlan?An IP phone shows a tftp server in the settings, is this provided by DHCP?The...

DirSync service was not started. Hi, I'm running cm6 in my vmware machine and have it configured to sync with my test active directory. I can add the ldap directory correctly, but how long does the sync take? My active directory has no more than 2...

I cut our CCME environment over to a CCM 6.0 system today, and I am having a really hard time getting inbound DID working.The CCM is connected to the PSTN with a PRI through a 2821 MGCP gateway. Outbound calls are working fine, even passing the corr...

Gurus,Soon I want to update my installation of CCME, which was installed about 2 1/2 years ago and has not been updated since.I used the Cisco Software Advisor, but am not sure which phone loads to choose. For instance, for the 7970 phone, this is on...

hello i would like to know if its posible to connect one ip phone on the 10/100 port of another ip phone and it work or we need to do anything special for work that connection.thanks

this is for p.bevilacqua -

I have CME 4.1 running on a 2801. For music on hold, we are using an external source. I have an ephone-dn with the moh out-call command pointed to a dial-peer that is connected to our music source. If you dial the dial-peer, you hear the music and...

How can an administrator disconnect a caller from a bridge? Can the administrator view what phones are attached to a meet-me conference? We have a meet-me conference bridge that is stuck in the "open" position. What can be done to disconnect attend...

I have configured a DSS/BLF on my 7960 for one of our DN's. Speed dial and busy display are working great. Is there any way to get it to show when the target DN is forwarded to voicemail? Thanks!

Anyone ever seen this issue? Calls to anything that are "unknown status" fail. This includes CTI RP and ports. 5.1.3.1000-12

Is external ringing supported on transfered or forwarded calls? The scenario is that all calls come into Unty AA. Calls are then blind transfered to the extensions. The users want to distiguish between internal and external calls. Right now, the CID ...