IP Telephony and Phones

Hey everyone:My customer doens't want to by the IPCC to have a call center capability. Actually his call center is only 9 agents so i guess we can do something using the call manager and/or UnityHis version is CCM 4.0 and Unity 4.0(5) can we do somet...

What is the report you can run in CCM to show you echo from the IP phones?

I need to connect CCM to h323 service provider. I have 2811 (c2800nm-ipvoice-mz.124-13a.bin) which is connected to h323 provider. I need to know what configuration i must do on 2811 and what to do on CCM. Thx in advance.

Hello everyone,I have another strange issue with an IP phone that doesn't want to ring.There are 4 analog lines plugged into an FXO card in the router, and all are configured the same. The lines are PLARed to the phones - and all but one are working....

HiOne of the admin guy setup password on MCS7825 Server. Is there way to bypass it as each time we cold start the server it asks for password.Thanks in advance.Shahid

Hello everybody,HELP ANYBODY.I work on a implementation that from PSTN any number can call to GDN 24133450, and then forward to another number on the PSTN.This is a E1 fractional ISDN PRI with 6 GDN and each GDN has 5 trunks. In order for the call go...

Hi,Cisco7941G with CCM5.0(4a), we tried to use the Plantronics 26716-01 cable which it says it does not require any amplifier and can be directly connected to the phone as per following:http://www.headsetsdirect.com/accessories/26716-01.htmlBut the h...

Hi to all,I have a an ata 186 (registered with a CCME version 4.0) to which an analog phone is connected.When an external call arrives to my ataa can hold the call and dial an internal ip phone but if the internal phone doest'n pick up and i resume ...

Dear Friends, i have only one CCM in my network, if it fails due to some problem, what happened to active calls, will all the active calls will be disconnected , can i make new calls while CCM is down. Pls note it, i have only one CCM. My next questi...

Hi All,I have a CCM 4.1 configured at 2 differents site Cluster1 & Cluster2 linked by a trunk.Calls are flowing successfully over the trunk.I have configure the directory and can access them on each cluster.My problem is that i cannot access director...

Hi,I am having problems with an FXO card in the UK (BT is the telco). Could anyone please post a working Voice-port config for a single analogue BT line connected to an FXO port?I have tried numerous settings and can't get it to work. When I make an ...

Hello , I need to know if there is some way in CME to guarantee necessary bandwidth for the ip call even when the HDSL or ADSL internet line are saturated .Thanks .

Hi,CCME is running on 3845 Router and CCME version 3.3. My question is what is the maximum number of IP Phones and Analog phones i can Configure or Connect?

we have two callmanagers 4.1(3), publisher and subscriber. we tried to register IP Phone A to publisher and IP Phone B to subscriber. after successfully register, IP Phone A can not call IP Phone B or vice versa. Does anyone know this behaviour?FYI, ...