Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,I have a 2811 router with Callmanager Express. I am using a VIC-4FXS/DID card for Direct Inward Dial Call.What is the procedure for setup DID?Thanks.
Hi, i'd like to know if there's anyone out there that can be of help. We can't seem to access our voicemails at the office, as we keep getting the response "message server offline" or something. I only know about the CallManager express, but i have v...
Dear all,I have a CME with timezone +8. the clock of CME is sync with NTP Server which is at timezone -13.on router -> show clock: it is 11:00a.m. 19-janon IP phone -> the clock is 07:00p.m. 18-janIt seem the IP phone get the clock of NTP Server.On c...
Hi all we plan an upgrade from Callmanager 3.3(4) to 4.2(3). We use BAT and TAPS to rollout new phones. What do I need to install and configure on the new callmanager 4.2(3)? Or has anybody a manual what is needed and how to set up BAT and TAPS in or...
Hi there...i really need help on this. My message server is offline, and i dont have savvy how to bring it back up. Can someone please guide me through this? Thanks.
This is a new problem affecting a set up which used to work. A call handler transfers a call to an external number, but when the call is answered, the caller still gets the hold music and the recipient gets silence. After hanging up, the called ext...
HiTrying to understand how you setup speed dials, in the phone button template you create a line for a speed dial and assign the phone template to the phone, how do you then configure the phone for the speed dial.I can setup the various lines in the ...
HiCould someone please confirm that these are all the port numbers used by the unified comms callmanager serverCisco CallManager (Call control for Cisco IP Phone) 2000 (TCP)Cisco CallManager (Call control for Cisco Access Analog Gateway) 2002 (TCP)Ci...
Hi My quetsion is aounr dht trust boundry setup of catos.When you enable qos globaly it sets all ports to untrust. What I have onsite is cisco ip phones adn notrel handsets. Both will be plugging into the cat switch.I want a universal config that wil...
We are looking at rolling out encryption on our CM 4.2 cluster. Does anyone have any experience doing this and if so are their any reasons we should not?
Is it possible to remove MOH from MeetingPlace Express? I have disable MOH in CCM, but I still have MOH on all conferences until the host joins the call.
I'm trying to manipulate outbound ISDN display IE on a H.323 gateway connected to a PRI. It appears that IP phone's "Alerting Name" is passed to the PRI, but I would like to override it with company name.Any ideas will be appreciated.Thanks.Pavel Bog...
