IP Telephony and Phones

Need some help on this one. It seems I have a user that gets a voice mail and MWI will light. It will stay lit for about 20 seconds and then it goes out. I think somehow Outlook is marking them read without the user reading them. Any suggestions ...

Hey all. I am trying to figuar out why I can not get caller ID to apper on my 79XX phones from an FXO card\port? I have Caller ID enabled from the phone company and enabled in the IOS per port.

Hi, In either a CCM4.X or 5.x environment, connecting to E1's with 30 channel, can the E1 be split in the following way?finance channel 1-5admin channel 6-10IT channel 10-21users channel 22-30 I know it's possible with CME using trunk-groups, how ...

Does any one have solution on record a phone (session)discussion/conversation. Do we need a external tape recorder or Call manager can store a wav file?

Hi,I have one router 2851 ios 12.4(11)T and working with SRST v4.0 connected to PSTN. I have one ata 186 (SCCP version 3.02.01(050429A)but i can?t receive faxes from PSTN . In config guide say "For ATAs that are registered to a Cisco Unified SRST sys...

Hello,I have an BRI MGCP gateway configured, on a 2811, with backhauling of BRI messages to CM5.When I get an incoming call, it shows up as 23XXXXXXXX.I want to be able to present this to the end user as 8023XXXXXXXX.However, I want to do this for on...

Hi All,I would like to know how to reset IP Phone to default factory. Is it the same to all Cisco IP Phone? I have 7911G, 7912G, 7941, and 7961. Thanks very much for your help.

Hello,Please can someone help. I am configuring Cisco 3560's to support Nortel phones. I have configured ports to be switchport mode dynamic desirable and have configured both a voice and access vlan as per below:interface range FastEthernet0/1 - 23 ...

Hi,I have a branch office connected to the central office using a PPP link. There is a CCM in the central site (3.3.4 sr2) and ip phones in the branch office.Using additional DSP on the Gateway of the Remote Office (Cisco1760) I've configured the CFB...

does anybody know how to make a script on cisco cue script editor

Hello,I have a question about my migration from CatOS to IOS native (720) on a 6509: Does this WS-X6608-T1 module (T1, 8 port) work with IOS? Currently running with catos 8.2.2Thanks for any input!

I thought the Partition and CSS Limitation was addressed in CCM 4.X. Straight out of the book: The maximum length of the combined CSS clause (device and pattern) comprises 1024 characters, including separator characters between partition names (for...

Hello,I would like to migrate a 7940 phone configuration to 7960 including all services/speeddials etc. Is this possible? How?thanks,Richard

Is there a way to run an International call report in Call Manager? To find out which International calls have been made and by whom. Any info would be great.